STARTER Installation of lever Install the lever 27 in the illustrated direction on the overrunning clutch 38 . 27 10778 30 Installation of front bearing Before the front bearing 30 is press-fitted, install the dust seal 31 . Press-fit the front bearing 30 in the front bracket with a press, using the pipe-like tool A . 13325 Stake the front bracket 32 side. CAUTION Avoid staking the previously staked points B. C: Staking points (4 places) 13326 Inspection of overrunning clutch Perform the following checks. If there is anything wrong, replace the overrunning clutch 38 . Check to ensure that when the shaft A is made to rotate in the direction B , it rotates smoothly.
Check to ensure that when the shaft A is made to rotate in the direction C , it is locked. 38 13328 54-42