11 11-21 Service standards Unit:
mm (in.) Location Maintenance item Standard value Limit Remedy 4 Outer valve spring Free length 67.0 (2.64) 64.0 (2.52) Replace Installed load [at 47.8 mm (1.88 in.) installed length] 330 N (33.5 kgf) [74.5 lbf] 290 N (29.7 kgf) [65.2 lbf] Replace Squareness – 2.5 (0.0984) Replace 5 Inner valve spring Free length 55.1 (2.17) 52.1 (2.05) Replace Installed load [at 40.5 mm (1.59 in.) installed length] 92 N (94 kgf) [20.7 lbf] 78 N (8.0 kgf) [17.5 lbf] Replace Squareness – 2.0 (0.0787) Replace 7 Exhaust valve Stem outside diameter φ8.93 to 8.94 (φ0.3516 to 0.3520) φ8.85 (φ0.348) Replace Sinkage from cylinder head bottom surface 1.3 to 1.7 (0.0512 to 0.0670) 2.0 (0.0787) Inspect every location Valve margin 1.5 (0.0591) 1.2 (0.0472) Reface or replace Seat angle 45° – Correct 8 Inlet valve Stem outside diameter φ8.96 to 8.97 (φ0.3528 to 0.3531) φ8.85 (φ0.348) Replace Sinkage from cylinder head bottom surface 1.1 to 1.5 (0.0433 to 0.0591) 1.8 (0.0709) Inspect every location Valve margin 1.5 (0.0591) 1.2 (0.0472) Reface or replace Seat angle 45° ± 15’ – Correct 7, 15 Exhaust valve stem-to valve guide clearance [Basic diameter:
9 mm (0.354 in.)] 0.07 to 0.10 (0.00276 to 0.00394) 0.2 (0.00787) Replace 8, 16 Inlet valve stem-to-valve guide clearance [Basic diameter: 9 mm (0.354 in.)] 0.04 to 0.06 (0.00157 to 0.00236) 0.15 (0.00591) Replace 17 Exhaust valve seat width 1.8 to 2.2 (0.0709 to 0.0866) 2.8 (0.110) Correct or replace 18 Inlet valve seat width 1.8 to 2.2 (0.0709 to 0.0866) 2.8 (0.110) Correct or replace 20 Cylinder head Bottom surface distortion 0.08 (0.00315) or less 0.2 (0.00787) Correct or replace Height from top to bottom surface 94.9 to 95.1 (3.736 to 3.744) 94.5 (3.72) Replace Tightening torques Unit:
N·m (kgf·m) [lbf·ft] Location Parts to be tightened Tightening torque Remarks 14 Glow plug 15 to 20 (1.5 to 2.0) [11.1 to 14.8] – 19 Exhaust manifold mounting stud 29 (3) [21.4] –