John Deere OMAL171363 (7430 and 7530) — Hydraulic Stabilizer Bars (If Equipped)

Hitch Adjusting Spreading Dimension Drive tractor to the center of the implement. Remove ring (B) and lift flap cover (A). Use lever (H) to adjust the spreading dimension. Category Groove LX009470 —UN—03JAN95 LX009819 —UN—03JAN95 II + IIIN 3 II + IIIN 3 III 2 Groove 1 is used on Category II tractors. III 2 Grooves (G) provide a guide in adjusting the spreading dimension. The groove (G) that corresponds to the relevant category should be aligned with the edge (see arrow). Then locate lever (H) on pin (C), put down flap cover (A) and secure with ring (B). Finally, adjust spacer (D). LX011649 —UN—31JUL95 IMPORTANT:

The spreading dimension must be large enough to prevent the draft links (E) from getting caught on sway blocks (F). If not, mechanical damage may occur. A—Flap cover B—Ring C—Pin D—Spacer E—Draft link F—Sway block G—Grooves corresponding to Category H—Lever LX001750 —UN—05APR00 OU12401,00015B6 -19-14DEC06-1/1 50-18 030612 PN=132