Lubrication and Periodic Service Safe Maintenance and Cleaning CAUTION: To perform service work at locations that are difficult to reach, it is essential to use suitable platforms or safety ladders. Particular care is required to perform service work and cleaning jobs at locations that are difficult to reach, e.g. adjusting roof-mounted lights, servicing the cooling system, adjusting the right outside mirror on tractors without a door on the right side and many other similar tasks. TS249 —UN—23AUG88 CAUTION: It is NOT permissible to stand on tractor components to perform such tasks unless the tractor components are intended for this purpose.
There is an acute risk of falling, especially if the tractor components are wet, dirty, or coated with ice. OULXBER,0001A59 -19-21FEB11-1/1 Using High Pressure Washers IMPORTANT: High-pressure washers are a very effective means of cleaning the tractor. To avoid damage to the tractor, do not go closer than 1 m (39 in.) and spray at an angle between 45 and 90° when cleaning sealing surfaces, seals and decals. Maximum pressure must not exceed 12000 kPa (120 bar; 1740 psi). T6642EJ —UN—18OCT88 Do not, under any circumstances, spray or wash components (e.g. the engine) with cold water when hot. Do not use rotary nozzles or water at temperatures over 50°C (122°F), and do not aim at seals.
Keep the water jet moving at all times. Cooling units, the hitch jaw, bearings and electronic/electrical equipment must not be cleaned with high-pressure washers. Follow the instructions in the high-pressure washer operator's manual and manuals of attached equipment. OU12401,0001C6B -19-24JUN09-1/1 85-1 030612 PN=210