Service / Daily or Every 10 Hours Checking the Engine Oil Level Engine oil level should always be between the marks on the dipstick. Do not start the engine if oil level is below lower mark on dipstick. A—Dipstick B—Oil filler neck LX1041434 —UN—20NOV06 LX1041430 —UN—17NOV06 OU12401,0001578 -19-18NOV06-1/1 Checking the Fuel Filter If water or sediment deposits have settled in filter, proceed as follows: 1. Open bleed screw (A). LX1041431 —UN—20NOV06 2. Open drain plug (B) by 3/4 of a turn. Retighten the plug as soon as water and sediment deposits have drained out. 3. Open drain plug (C) by 3/4 of a turn. Retighten the plug as soon as water and sediment deposits have drained out. 4.
Tighten bleed screw (A). 5. Turn key in main switch to the right to the first switch position so that the fuel transfer pump is operating. Keep the pump running for approx. 40 seconds. If water was present in fuel filter, use a 1/2-inch square-section key to loosen drain plug (D) under the fuel tank by one turn. After draining off any water and sediment deposits, retighten drain plug until hand-tight. LX1031622 —UN—23JAN06 A—Bleed screw B—Drain plug C—Drain plug D—Fuel tank drain plug OU12401,0001579 -19-18NOV06-1/1 90-1 030612 PN=219