Service / As Required Check Coolant Level If coolant temperature is too high, rectify the cause (dirty radiator, clogged screen, coolant level too low). Coolant level should be close to the max. mark (A). It must under no circumstances fall below the min. mark (B). LX1044437 —UN—11DEC07 A—Max. mark B—Min. mark OU12401,0001D1F -19-15OCT09-1/1 Checking the Fuel Filter If water or sediment deposits have settled in filter, proceed as follows: 1. Open bleed screw (A). LX1041431 —UN—20NOV06 2. Open drain plug (B) by 3/4 of a turn. Retighten the plug as soon as water and sediment deposits have drained out. 3. Open drain plug (C) by 3/4 of a turn.
Retighten the plug as soon as water and sediment deposits have drained out. 4. Tighten bleed screw (A). 5. Turn key in main switch to the right to the first switch position so that the fuel transfer pump is operating. Keep the pump running for approx. 40 seconds. If water was present in fuel filter, use a 1/2-inch square-section key to loosen drain plug (D) under the fuel tank by one turn. After draining off any water and sediment deposits, retighten drain plug until hand-tight. LX1031622 —UN—23JAN06 A—Bleed screw B—Drain plug C—Drain plug D—Fuel tank drain plug OU12401,0001579 -19-18NOV06-1/1 Bleeding Air from the Fuel System CAUTION:
High-pressure fluid remaining in fuel lines can cause serious injury. Do not disconnect or attempt to repair fuel lines, sensors or any other components between injection pump and nozzles. LX1041442 —UN—21NOV06 The fuel system must be bled whenever the fuel tank has been run dry or the fuel filters have been replaced. Turn key in main switch to the right to the first switch position so that the fuel transfer pump is operating. Keep the pump running for approx. 40 seconds. OU12401,000157D -19-18NOV06-1/1 125-5 030612 PN=253