Troubleshooting Hydraulic System Symptom Problem Solution Hydraulic system fails to function Not enough oil in the system Correct oil level. Open electrical circuit Check fuses. Filter plugged/by-passed warning is active Filter plugged Replace filter. Hydraulic oil overheats Cooling system overloaded Dirty oil cooler. Coolant level low. Selective control valve accidentally locked in operating position Move selective control valve to neutral position. Hitch fails to lift load Excessive load on hitch Reduce load. Hitch rate-of-drop too slow Rate-of-drop not adjusted properly Adjust rate-of-drop.
Insufficient sensitivity to load control System regulator in depth control or mixed control position Move system regulator to load control position. Excessive sensitivity when attaching implements System regulator in load control position Place system regulator in depth control position. SCVs not operating Hoses not connected properly Connect hoses properly. Remote control cylinder operates too fast or too slow Incorrect setting for rate-of-flow With M-SCVs/M-ICVs, adjust the flow control valve. With E-SCVs/E-ICVs, adjust the rate of flow at the CommandCenter. OU12401,0001D20 -19-15OCT09-1/1 130-1 030612 PN=271