Diagnostic Trouble Codes and Customization UIC Control Unit The UIC (User Interface Control Unit) processes the various commands given by the operator with regard to speed and direction of travel. Light Diagnostic trouble code Basic description Description yellow UIC 000606.16 Engine Engine speed too high. Reduce travel speed. blue UIC 001504.30 Controls Before starting to drive, actuate brake or clutch and move to park position. blue UIC 001504.31 Controls Before starting to drive, sit on seat or actuate brake or clutch and move to park position. blue UIC 001713.15 Hydraulic oil filter restricted Filter needs to be changed soon.
yellow UIC 001713.16 Hydraulic oil filter restricted Change filter. blue UIC 002240.09 TEC control unit Incorrect CAN BUS Message * yellow UIC 520283.14 Implement Tractor-Implement Automation deactivated. ** blue UIC 523956.31 Controls When starting, move lever to forward or reverse. Shift to park position and start again. yellow UIC 523957.31 Electrical System When starting, move lever to forward or reverse. Shift to park position and start again. blue UIC 523966.11 Come-home mode is active. Restart. blue UIC 523960.31 Controls Before starting to drive, sit on seat or actuate brake or clutch and move to park position. blue UIC 523966.14 Come-home mode is active. Select direction of travel.
blue UIC 523966.31 Come-home mode is active. Move lever to park position or neutral. yellow UIC 524020.31 Controls When starting, move lever to forward or reverse. Shift to park position and start again. blue UIC 524180.07 Come-home mode is active. To stop, actuate clutch pedal. blue UIC 524180.14 Come-home mode is active. Actuate clutch pedal. blue UIC 524180.31 Come-home mode is active. Release clutch pedal. blue UIC 524190.14 Transmission Slip control is active. blue UIC 524193.14 Transmission oil temperature is low. Vehicle does not operate until oil is warm. blue UIC 524193.31 Transmission oil temperature is low. Shift to park position. * Tractor-Implement Automation is deactivated.
The diagnostic trouble code can be generated due to a poor ISOBUS connection between tractor and implement. ** Tractor-Implement Automation is deactivated. The tractor can be driven after the reverse drive lever has been moved beyond the corner park position. With Tractor-Implement Automation the following operator errors cause this fault: Operator leaves the seat Reverser lever is moved without request. ISOBUS connector of implement is disconnected. If other diagnostic trouble codes appear, one of the tractor's sub-assemblies is either not working properly or not working at all. Make a note of the code and contact your dealer.
OU12401,0001D78 -19-16NOV09-1/1 UIM Control Unit The UIM (User Interface Module) is responsible for the keyboard of the GreenStar Display 2100. If diagnostic trouble codes appear, one of the tractor's sub-assemblies is either not working properly or not working at all. Make a note of the code and contact your dealer. OU12401,00013ED -19-06APR06-1/1 135-10 030612 PN=283