Controls and Instruments 20-This light comes on when the reverser lever is in reverse position. 26-This light comes on when front PTO is engaged. Light test: As the engine is started, all the lights should come on for approx. 1 second. If this is not the case, a defective bulb or blown fuse may be the cause. Check and replace parts as necessary. 21-This light comes on when the reverser lever is in park position (with AutoPowr / IVT transmission). 22-With PowrQuad Plus or AutoQuad Plus transmission, figures 1-4 indicate which gear is selected. The indicator lights should go out as soon as the engine is running. 23-This light comes on when the AutoPowr / IVT transmission is in creeper mode.
NOTE: Travel speed can be displayed in km/h or MPH. This setting can be made at the CommandCenter. In this section, see the Units of measurement screen in CommandCenter settings. 24-This light comes on whenever the transport lock of the electrical multi-function lever is activated. 25-This light comes on whenever the transport lock of the E-SCV/E-ICV is activated. OU12401,0001CEF -19-28JUL10-2/4 Fuel gauge The fuel gauge shows the amount of fuel in the tank, from full to empty (end of red). When the indicator needle enters the red, there are still approx. 35 liters (9.2 U.S. gal.) remaining.
LX1036201 —UN—31MAY06 OU12401,0001CEF -19-28JUL10-3/4 Coolant temperature gauge If the coolant gauge needle moves into the red (A), the engine is overheating. Immediately reduce load or shift to a lower gear. If the needle remains in the red, shut off engine and determine cause of overheating (coolant level low, dirty radiator or dirty radiator screen). LX1036202 —UN—31MAY06 OU12401,0001CEF -19-28JUL10-4/4 15-7 030612 PN=38