John Deere OMAL171363 (7430 and 7530) — Cigarette Lighter and Ashtray

Operator's Cab Adjusting the Height of Access Step The height of step (A) can be adjusted. Take out screws (B). Move access step to desired position. Put screws (B) back in. NOTE: If the rear tires have an index radius of 820 mm (32.3 in.) or over, the step must be set at the bottom position. LX1036253 —UN—03JUN05 A—Access step B—Screws OU12401,000122E -19-25MAY05-1/1 Installing the Monitor Attaching the performance monitor and controls There are several possible locations for attaching monitors and controls in the cab: On the front right post. On the center posts. On the rear posts. LX1036239 —UN—03JUN05 LX1036240 —UN—03JUN05 NOTE:

Gap between holes at attaching points is 120 mm (4.72 in.); thread is M10. Take off the relevant trim and turn it over. The positions where holes may be made are already marked. LX1036241 —UN—03JUN05 LX1036242 —UN—03JUN05 OU12401,0001227 -19-24MAY05-1/1 25-14 030612 PN=67