BEFORE YOU OPERATE 12/05 MARINE GEAR OR SAIL DRIVE OIL 1. Make sure the engine is off. Make sure the engine is as level as possible and wipe area clean around the marine gear filler port (Figure 7, (2)) . Marine Gear Oil Specifications Use marine gear oil that meets or exceeds the following guidelines and classifications: 2. Remove the filler cap at the top of the housing. 3. Remove the dipstick (Figure 7, (1)) and wipe with a clean cloth. KM2P-1 (S), (G) or (GG): API Service Categories: CD or higher SAE Viscosity: #20 or #30 Sail Drive Oil Specifications- SD20 4. Re- insert the dipstick without screw in, please see illustration (Figure 7) . 5. Remove the dipstick.
The oil level should be between the upper (Figure 7, (3)) and lower (Figure 7, (4)) lines on the dipstick. Refer to the Sail Drive Operation Manual for the procedure to fill or replace the sail drive oil. SD20: 6. Screw in the dipstick. API Service Category: GL4.5 Adding Marine Gear Oil SAE Viscosity: 90 or 80W90 1. Make sure the engine is as level as possible. Checking Marine Gear Oil 2. Remove the filler cap at the top of the housing. NOTICE Never overfill the marine gear with oil. 1 3 3 4 3. Fill with oil to the upper limit on the dipstick (Figure 7, (3)) . See Marine Gear Oil Specifications on page 29. 4 4. Screw in the dipstick. 5. Hand-tighten the filler port cap.
Checking and Adding Sail Drive Oil 2 054316-00X00 Figure 7 Refer to the Sail Drive Operation Manual for the procedure for checking and filling the sail drive oil. 1 – Dipstick (Filler cap combined type) 2 – Marine Gear Filler Port 3 – Upper Limit 4 – Lower Limit (Dipstick end) Y M Series Operation Manual 33