Kaiyi UDRF01.04GB — 6.3 Tyre and rim system

16 6 Suspension – 6.3 Tyre and rim system 2 Place clamps and nuts on the wheel bolts. Where applicable, also washers. 3 Remove the lifting equipment. 4 Fit the wheel. Tighten the wheel nuts crosswise with torque 400 Nm . 000383 5 Inflate the tyre with air, 1 MPa , see Tyres, inflating page 17 . 6 Lower the axle and remove the jack. 7 Test-run the machine and check that the wheels are installed securely. 8 Check-tighten the wheel nuts with torque 400 Nm . 000384 Example: The figure shows inflation of drive wheel. UDRF01.04GB Maintenance manual DRF 400–450