7 Load handling – 7.3.10 Lift boom 13 7.3.10 Lift boom page Glide plates lift boom, checking NOTE When adjusting side-mounted glide plates, it is important to check the clearance for the whole boom's stroke. 1 Place the boom in the lowest position (fully retracted). 2 Check wear of the side-mounted glide plates at the leading edge of the lift boom. If needed, remove the glide plate and measure the thickness. Thickness should be at least 25 mm . NOTE If the glide plate's thickness is less than 25 mm, the glide plate may work loose from the bracket, which may result in boom damage.
3 Check the clearance between the boom and glide plate, clear- ance should be 1 mm , adjust with spacer plates if needed. 1. Side-mounted glide plates 2. Lower glide plates NOTE The inner boom shall be centred in the outer boom. 4 Check thickness of the lower glide plates at the leading edge of the lift boom. If needed, remove the glide plate and measure the thickness. Thickness should be at least 15 mm . 5 Check the clearance between the boom and stop at the leading edge/top edge of the boom, clearance may be max. 3 mm . Ad- just the glide plates with spacer plates if needed. 6 Check wear of the lower and side-mounted glide plates at the trailing edge of the lift boom.
If needed, remove the glide plate and measure the thickness. Thickness should be at least 25 mm . NOTE If the glide plate's thickness is less than 25 mm, the glide plate may work loose from the bracket, which may result in boom damage. 7 Check the clearance between the boom and glide plate, clear- ance should be 1 mm , adjust with spacer plates if needed. 1. Upper glide plates 2. Side-mounted glide plates 3. Lower glide plates 8 Check thickness of the upper glide plates at the trailing edge of the lift boom. If needed, remove the glide plate and measure the thickness. Thickness should be at least 15 mm . UDRF01.04GB Maintenance manual DRF 400–450