30 7 Load handling – 7.6.6 Rotation motor unit 7.6.6 Rotation motor unit page Oil rotation motor unit, changing WARNING Hot, pressurized oil. Personal injury, burn injury, rash or irritation. Always depressurize the hydraulic systems before starting to work on the hydraulic systems. Avoid skin contact with the oil, use protective gloves. 1 Clean the area around the rotation motor unit. 2 Place a receptacle under the rotation motor. 3 Remove the planetary gear's drain plug (pos. 6) and lead the oil into the receptacle. Remove the planetary gear's filler plug (pos. 3) for faster drain- ing. 4 Remove and clean the planetary gear's level glass (pos. 5) while the oil drains.
5 Fit the level glass and drain plug. 6 Fill the planetary gear with new oil through the filling point (pos. 3) until the level is in the middle of the level glass. For volume and quality, see section F Technical data . 7 Remove the disc brake's drain plug (pos. 4) and lead the oil into the receptacle. Remove the disc brake's filler plug (pos. 2) for faster draining. 8 Remove and clean the disc brake's level glass (pos. 1) while the oil drains. 9 Fit the level glass and drain plug. 1. Level glass, disc brake 2. Filling point, disc brake 3. Filling point, planetary gear 4. Draining, disc brake 5. Level glass, planetary gear 6.
Draining, planetary gear 10 Fill the disc brake with new oil through the filling point (pos. 2) until the level is in the middle of the level glass. For volume and quality, see section F Technical data . UDRF01.04GB Maintenance manual DRF 400–450