16 8 Control system – 8.4 Diagnostics page Diagnostic test, work instruction To select diagnostic test, proceed as follows: 1 Navigate to the service menu. 2 Press Enter. 3 Enter code for diagnostic test. Code is obtained from Kalmar Industries Support. NOTE The code determines which service menu is activated (Di- agnostic test, Initiation or Calibration). UDRF01.04GB Maintenance manual DRF 400–450 Pos. Designation Description 1 DIAG Indicates that diagnosis has been selected. There is also initiation (INIT) and calibration (CAL- IB). 2 CAB Indicates which menu group is selected. These groups are available: CAN/POWER - for diagnosis of CAN-bus and power supply.
LIGHTS - for diagnosis of lighting and lights. CAB - for diagnosis of components in cab. CLIMATE - for diagnosis heating and ventilation system. HYD - for diagnosis of common hydraulics and brakes. ENGINE - for diagnosis of engine. BOOM - for diagnosis of lift, lower and extension. ATTACH - for diagnosis of attachment. OP - for diagnosis of overloading system. EXTRA - for diagnosis of optional functions. HIST - not used. 3 2 Number of menu in question (menu group CAB contains several menus in a loop). 4 (10) Total number of menus in the group CAB. 5 Variable Signal that is measured. Here are a few examples. SWITCH refers to switch windshield wiper.
OUTPUT refers to status for a supply, in this case supply of the wiper motor. FEEDBACK refers to a feedback signal, in case signal from wiper motor when it operates. 6 7 Signal value FRONT WIPER Measured value or status of signal for variable on the same row. Name of the function that can be controlled. FRONT WIPER means windshield wiper front. 000056 1 2 3 4 5 000060 1 2 3