9 Frame, body, cab and accessories – 9.10 Cab structure and suspension 25 9.10 Cab structure and suspension page Cab structure and suspension, description The cab has a level floor with a bracket for the operator's seat. It is suspended in a cab undercarriage via heavy-duty rubber pads locat- ed on the bottom of the cab. This is to minimize vibrations from the frame to the cab. There are rubber pads at four points, one in each corner. Each rubber pad mounting has a rubber bushing and a bolt. 1 2 There are different types of cab suspensions.
Manual movement of cab, description page 25 3 Hydraulic sliding cab, function description page 26 4 003206 Cab lift and lowering, function description page 28 Cab Spirit Delta 1. Cab frame 2. Door 3. Suspension of cab 4. Cab undercarriage NOTE Cab mounting does not affect the cab's version. 9.10.4 Longitudinal displacement of cab page Manual movement of cab, description Manual cab movement means that the cab can be moved forward to facilitate access for service and maintenance in the engine com- partment. The cab is pushed for and aft by hand. Two cable chains on each side ensure that hoses and electric cabling to and from the cab are not damaged when the cab is moved.
The cab is secured in the rear po- sition during operation with two lock catches at the trailing edge of the cab. A DANGER The cab may start to move. Fatal danger! The cab is heavy. The machine must under no cir- cumstances be moved with the cab unsecured. Se- cure the cab with the lock catches before operating the machine. B C 000270 A Position lock handle B. Lock pin C. Lock catch for securing cab UDRF01.04GB Maintenance manual DRF 400–450