14 C Preventive maintenance – Preventive maintenance page Lubrication 500 hours 1 Clean the area around each grease cup before greasing. 2 Grease all points with lubrication grease, see section F Techni- cal data . Wheel hub and wheel spindle 3 Raise the right steering wheel with a jack (40 ton) so that wheel bearings and wheel spindle are relieved of stress, do not lift to a height where the wheel hangs freely. 4 Grease the wheel hub until grease comes out at the seal on the hub's inside. Lift the seal ring's lip with a small screwdriver to facilitate pressing out of air. Grease until grease comes out by the seal. NOTE Work carefully so that the seal is not damaged.
Grease point wheel hub 5 Grease the wheel spindle's upper and lower bearings. NOTE It is important that both upper and lower bearings are greased separately since the grease is not pressed be- tween the bearings. 6 Lower the wheel. 7 Repeat steps 3 - 7 for the left steering wheel. Grease points wheel spindle 1. Upper grease point 2. Lower grease point UDRF01.04GB Maintenance manual DRF 400–450