Kaiyi UDRF01.04GB — 1.7.2 Coolant filter

1 Engine – 1.7.2 Coolant filter 17 page Coolant filter, changing (Cummins engine) NOTE Close the shut-off valve before the filter is loosened. Coolant may run out resulting in environmental damage. 1 Machine in service position, see section B Safety . 2 Close the shut-off valve on the filter holder. 3 Clean the area around the coolant filter. 4 Place a receptacle under the coolant filter. 5 Remove the coolant filter with filter tool. 6 Lubricate the O-ring on the filter cartridge with engine oil. 7 Fit the new filter. 8 Open the shut-off valve on the filter holder. Tighten to contact and then another half to three-quarter turn. NOTE Do not forget to open the valve after changing.

Otherwise, the coolant does not pass through the filter and is not cleaned. Filter left side, Cummins engine 1. Shut-off valve, coolant 2. Coolant filter 3. Oil filter 10 Check that the coolant filter seals tight. 9 Turn on the main electrical power and start the engine. 11 Remove the receptacle. Handle the coolant as environmentally hazardous waste. 12 Check the coolant level in the expansion tank, top up if needed. A B C 004851 A. Position of coolant reservoir (expansion tank) B. Filling point C. Level marking, MIN and MAX UDRF01.04GB Maintenance manual DRF 400–450