PIPER COMANCHE SERVICE MANUAL. NOTE When totqum, various UlClftbties. IUDdatd torque Ydua are to be uNd as found in Section 11 of this 1llUU&l or FAA AdviIory CircuJar 43.13--1A. wUcs' otherwise .tated in tbiJ manual. The dilaacmbly I aucmbly I and riJIinI of component pam to die vulOU. eontrol surfaces can be found in Section V of this manual 4-02. DacripDoD. The ItrUc:mfa of the PA-24 ate of meet aluminum. cOlllp/,etel.y primed with zinc chromate and covered with acrylic lacquer on che eXWlior surfaces. Each win, airfoil section is a full c:antileva' lamina flow type.
The fulllen,th beam type nWn spar is joined with high strenfth butt fittinp in me center of the !ute mak:iDI in e:ff«t a conUnuous maiD The fuselqe is an all meW semi-monocoquc cOllRNcQon cOIIlpriled of bWkbads, SD"iDge1. Itiffenen. and 10npauUnai beams to .hich die GUm skiD is riveted. spar. The an metal empcDDap FouP is a fvJ1 cumewr daipl coDIiftiDI of & vercical fin. rudder. and .tabilator with ~ trim tab. The stabilator and vertical fm haft ",0 cbaDDellllaiD spm ruDDiq full length. The subilator is attached to the fuscllce by & torque tube supported by beariq blocks. 4-03. Removal. "'"'4. Removal Of W"ID, ~dlbly.
The major subUlClDbiies of the wiDe may be remowd individually or the wing may be removed as a unit. To remove the wiDe. & fuIeJap supportiq endle is required. also & wing sup pan . ..... 5. Removal Of WiD, rap. a. Remove the Kft'W. holdiq the win( ~ to the wq. b. Pull the wing tip far alougb off to ciilconnect the ll&viptiOD light wire at the quidc.-disconncet fittins; then remove the win. tip. 4--6. Removal Of x..diD1 LiFt ADd HoUliDt. a. Remove wing cp. b. Remove the sheet mew screw. from the luuIiDIliIht window .-mbly 0, Fipe .... 1.) c. Remove the machine.crews and clamps (2) ho1dm, the lamp (3). d.
Pull the lamp forward and remove the eiecaic:a1leads (4) from relZ' of the lamp; then remove the clamp. e. To disassemble me Ianq light housin,. remove the screws located in the comers of the housing. f. Make sure that the eleetrica1lcads to the lamp are disconnected prior to removal and chat the lamp is not dropped when the front clamp and rear bracket arc separated. STRUCTURE ISSUED: 8/18172 1 E8