PIPER COMANCHE SERVICE MANUAL AU1 1. NUT 2. WASHER 3. SPACER 4 Sl'ACER WASHER 5. BOLT a. WING FITTING 7. FLAP FITTlNG a. BOLT t. TRACK 10. ROLLER. NYLON @7 'O~ (ELECTRICALLY OPERATED) FIGURE 4-... AIL!RON BEARING FIGURE 4·3. FLAP ROLLER INSTALLATION I"ST ALLA TIOH f. In the ri&ht winC, by nteMC throup the wbe.l well, draw the flap return step lock cable and connect. Encace the step lock. In the l.ft willi CODliect the nap retum sprinl. i· Check nap riainl and adjustments. (Refer to RilPI Of Flap, Seetioa V.) h. Install acce plates aad wheel weU splub pill. "OTI When inatl11inl nap roller., poaition apacer wuhera to aUow no side bindina aad a.certain that the roller bushina' will roll free.
4-26. Installatian Of Flop. (''''24-400) a. Ascertain that the nap control rod ~ instaned on the flap. b. Position the nap in place, lubricate the flap roUers aad tracka(Refer to Lubrication Chart. Section II) and install the lower roUer ... embli (Refer to tip. 4-3.) c. Swing the nap rearward and install the remaining assemblies. \'love the Hap thzough its full travel to ascertain that there is no bindina. d. The right flao. inaert the ste;» loCk cable tbrollch the l dinl edle. e. Connect:he flap contml rod to the ~el1crank. f. Enter throll&h the riabt wheel well Md connect the step iock return sprina. Engage the step lock. I.
Check flap riginl and adjustllleftt (Refer to R!.a&inl Of Flap, Section V.) h. Install acc ... plates and wheel well splash pan. 4-2i. In'tallation Of AiI.ron. a. Position the aileron. lubricate (R.fer to Lubrication Chart. Section II) and install the in- board hinge bolt. (Refer to figure 4-4.) Install the outboard bolt. Place the spacer washers to allow for best alignment of hinges. ~ove the aileron throuah its full travel to ascertain that there is no binding. STRUCTURE ISSUED: 8/18/72 1 E14