PIPER COMANCHE SERViCE MANUAL 5·28. Rudder Trim ConIZ'OJs. 5·29. Removal Of Rudder Trim MecbaDiIm. (Refer to Fiprc 5-8.) a. The aim mechanism may be removed by disconnecti .. the unit at the cockpit conaol and at the nOK ,eu stem .. ann. Note the number of washers between the ball joint and stecrinl ann. 5·30. I ..... n Of Rudder Trim. (Refer to Fipre 5-8.) a. Connect the rudder trim mechanism at the cockpit cOllaol and at the nOle ICU' stecrilll ann. Rig and adjua per puqraph '.J 1. 5·31. Rigin, ADd AdjUftlll4l!lIIt Of Rudder Trim Mmenilm. (Refer to Fipre , ....) a. To rig the rudder aim mechanism.
uce:ruin that the rudder pedals are neutral (Refer to Fiprc 5-8) and the note ,ear steering is adjusted and CCDteI'ed accordiDc to Puqraph 6-%3 of Section VI. b. With the rod ead (18) dilconnectcd from the DOle ,ar SlftI'iDI anD. tum the trim lmob to indicate neutral. Within the CftIinc compartmcat. tum die buaree tube- (12) on the aim screw (11) to maintain the fonowing distance ~eeD the fiR wall &lid tube end. PA-24-180. Serial Nos. 24-1 to 24-1676 PA-24-180. Serial Nos. 24-1684 UId up PA-24-250 and PA·24-260 PA-24-400 .815 iJIch .562 inch .562 inch .815 inch Adjust the rod end (18) to allow the bolt to slip into place.
Place spacer washers between the rod end and stemng arm so a.s to allow no up or down binding of the buJllft tube on the trim screw. Do nOt exceed over seven wunm. 5·32. Sabilator ConaolJ. 5-33. Removal Of ScabilaCDr Coouou. (Refer to Filan: 5.10.) I. To remove the stabilator control cables. remove the left forwU'd floor panel. rar scat. baa. compartment rear bulkhead panel and &Ccca pancllocat~.jUlt ahad of the Rabilator on the fiCht side of the fuscl&le. b. F or the removal of the forwU'd control cable. n:licve cable tension and disconnect the two tumbuckles (5) located to the rear of the fulelate Dar the radio rack. The upper tw'ftbuc:kle ends should be marked to facilitate reima U'tion.
Remove the contrOl able pards or pulleys (1) alone the bottom of the fusclqc. Draw the cable forward from benath the floor PUlc1. At the puUey dURer located at the fire wall. remove two cable guards and bri .. the cable around the pulley cluster. Remove the pulleys (44) bchiDd the instrument pando disconnect the cable from the contrOl column and remove the able. c. The aft stabilator conaol cables may be mnoved by dilConncctiq the cables at the stabilator balance (29) and rcmovin, the cable pulleys. d. To remove the subilator torque tIIbe UlCmbly. remove the tail cone fairinp. stabilator (refer to pangraph 4-1S of Semon IV) and subilator trim mechanism.
(Refer to Panpapb 5.37.) Disconnel:t the cables from the balance ann. Remove the nutS securing the bearing blocks and remove the UlCmbly. Should SURFACE CONTROLS ISSUED: 8/1Bn2 IG19