BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL g. Lubricate the inner wall of the cylinder (33) with hydraulic fluid. Carefully insert the PistO" . assembly into the bottom of the cylinder. allowing the orifice tube to guide itself into the piston tube. u~P' snap ring (49) can be installed in the annular slot at the bottom of the cylinder. h. At the top of the cylinder (33). tighten the orifice tube locknut (22). 1. Install wiperstrip (47), slide washer (48) into position and secure assembly with snap ring (49). j. Ascertain that bushings are installed in the upper and lower torque links (4 and I) and then install both links.

NOTE Ascertain that the torque links are properly installed to insure complete travel of the piston tube and fork assembly within the oleo housing. The torque link bolt assemblies should be lubricated and installed with the flat ofthe bolt head hex adjacent to the milled stop on the wide end of the link. Tighten the bolts only tight enough to allow no side play in the link. yet be free enough to rotate. k. Ascertain that the upper and lower oleo housing bushings (20 and 32) are installed. 1nstall the cylinder into the oleo housing and secure with snap ring (19). I. At the top of the oleo housing, install on the cylinder the aligner guide bracket (18) and steering arm (28).

Install cap bolts (7). tighten to 30 to 3S inch pounds torque and safety with MS2099SC40 wire (6). m. Install the shimmy dampener (13) using bolts, washers and nuts (12) and safety with cotter pin. n. Lubricate the gear assembly. (Refer to Lubrication Chart. Section II.) o. Compress and extend the strut several times to ascertain that the strut will operate freely and torque links do not restrict travel in the compressed position. The weight of the gear wheel and fork should allow the strut to extend. p. Service the oleo strut with fluid and air. (Refer to Oleo Struts. Section II.) q. Check the nose gear for alignment (refer to paragraph 6--16) and gear operation. 6-12.

Removal of Nose Landini Gear. (Refer to Figure 6-3.) a. Disconnect the gear door actuating rod and air intake hoses at the bottom cowl. b. Remove the bottom cowling by removing attaching screws and brackets. c. Place the airplane on jacks. (Refer to Jacking. Section II.) d. Remove the down limit switch (29 or 43) from the left drag link (28) by removing switch attaching nut and electrical straps. The electrical wires may remain connected. e. Disconnect the retraction transmission by pulling up on the release lever. f. Retract the landing gear by using the emergency extension lever. until it hangs in the neutral position. g.

Disconnect the nose gear door actuating rods from their mounting brackets by removing attaching nuts and washers. h. Partially retract the landing gear until the nose gear push-pull rod attaching bolt (26) clears the wheel well and then remove bolt. i. Partially retract nose gear and remove downlock spring(s) (33) by removing nuus), washer(s) and bolus) securing the spring attachment linkts) to the drag link cross brace (30). j. Push up on the nose gear door actuating arms and remove bolts (22) securing the upper left (28) and right (18) drag links to the gear mount. Note spacer washers (21) between drag links and mount. K. Remove cotter pins. nuts.

washers and bolts (9 and 20) from the strut housing attaching arms and gear mount. Note the number of spacer washers (8 and 19) between the strut attaching arms and the gear mount. I. Remove strut assembly and drag links from wheel well. REVISED: 4/10/81 114 LANDING GAER AND BRAKE SYS_