BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL \ cs.S2. Adjultmet1t Of 1.aDdint c;c. Safety Switch. _ a. The Iandi", pr safety switch iocated on the left main ,eat is adjuSted so thc switch is actuated in the last 0.75 of an iDCh of ,car extension. b. The switch with the boot seal and adjustin, rod (refer to Fipre 6-9, Sketch B) is adjusted by placina the ,ear in fun down position and the strut fully extended. Screw the leNator arm (41) down until the switch clicks on. then screw down an additional 0.117 of an inch and secure with jam nut (40). c.

The round switch used on aircraft without the a.d~ rod and arm" adjusted by toml'fCSlinc the strUt until S.S inches is obtained betWeen the tOp of the par fork (34) and bottom of the ,eat housiftJ (15), then adjust the switch down until it contaCtSthe smker plate. Secure the switch and safety. d. Ascmain that either switch will aemate in the Jut 0.15 of an inch of oleo extension. cs.S3. Adju.scmcnt Of The Gar Down Limit Switch. a. Before ancmptiftJ any adjusancnt of the down limit switch. ucc:rtain that the nOK and main gear drq link assemblies are properly adjusted. Refer to panpaph. 6·15 and 6-34. b. Each main ,ear down limit switch attached to the sid.:

brace dfll tint assembly is adjusted by moving the switch toward or away from the Sft'iker place. When the Iandiq ,ar is down and locked. the limit switch should have broken contact. c. The noSC gear down limit switch located at the left drq link is adjustcd by moving it toward or away from the striker plate. When the ,ear is down and locked. the switch should have broken contact. d. Check operation at the down limit switches by the fonowm, procedure: 1. Open landin, gear retraction motor circuit breaker. 2. Tum on the muter switch. 3. DisconneCt the rcmc:tion traftsmiuion by puUi .. up on the rclc:uc lever and manually rctrl.cri"l the land"" Iftr UM, the emergency extension lever. 4.

At the point where the IftCn light ,acs out. apply rearward pressure on the nose gear and inward pressure on the main gear. The ,ear should not unlock. 6·54. Adjustment Of Gar' RetractiOn TnnmUuion Aaanbly. (Refer to Figure 6--14.) .~djust the retraction transmission by using the following procedure: a. Release the re~ction tranSmission by pulling up on the mlCrJCncy release lever. b. Adjust the pushwpuU cables so the cable (1) from the ",ht Iftr has three threads exposed forward of the cutellated nut and the cable (2) from the left ,ear has one thread exposed forward of the castellated nut. (A spanner wrench may be fabricated to tighten the c:utellatcd nuts.

See Fiprc 6-40.) NOTE Thc main gear push·pull cables cross each other aft of the rcmaion transmission. LANDING GEAR AND BRAKE SYSTEM ISSUED: 8/18/72 IJ16