PIPER COMANCHE SERVICE MANUAL 6-58. Ocdtint Landi .. Gar Rcuaalon Load. (Refer to FilUm 6-19 and 6-20.) After the landint gear hu been lubricated and property adjUSted u described in the precediDc panpphs. check rctraetion load by USlftI the followiJll procedure, a. Place the &itplaneon jacks. (Refer to I-wn,. Section II.) b. With the ,ear fully extended. disconnect the rftnCtion transmislion auembly by pullina up on the cmC11ency relcuc lever. c. Putially rCUlct the ,ear until it hanp In the neutnl position. by lUina the euqency cxtmsion lever. d. On airplanes with Serial Nos. 24-1 to 244782 inclusive and 24-4184 to 24-4803 inclusive.
remove the red knob on the cmCTJency extension lever and insraU adapter tool. PIN 26348. on the lever with att&chilll bolt forward. (Refer to Fipre 6-19.) e. On &itplana wi:h Serial Nos. 24-4783 and 244804 and up. remove retrae:tion ttansmiuion floor plate and insu.ll adapter tool. PIN 26347. in the left socket of the mraaion torque Nbc. (Refer to Figure 6-20.) f. Ascmain that the shoulder of the adapter is seated on the cxtCftSion handle or on the torque rube socket. g. Open the gear motor circuit breaker to prevent mOtor from runnm, duri", ,ear check. h. Panially retract landing ,ear uGn, adapter and install torque wrench on adaptct.
alifning the centerline of the torque wrench w~th the ccntcrliM of the rettae:tion torque Nbc. i. Tum on the mastct switch and slowly puU aft on the torque wrench completely remctina the gear. j. Observe torque reading when the amber pi' up indicator qht initially comes on. The torque reacting should not exceed limits given in Table VI·l, k. If torque exceeds the limits specified. check for the (oUowin" 1. Insufficient lubrication. possible bindinJ. improper adjuStment and damaged parts of the retraction system. 2. Check the up limit switch for proper adjustment. It may not actuate soon enough causing the main ,ear to be pulled too hard against the rubber stop blocks.
exerting excessive load on the system. The main gear should fit snugly against the rubber stop blocks in the wheel well. LANDING GEAR AND BRAKE SYSTEM ISSUED: B/18n2 IJ23 TABLE Vl-1. TORQUE FOR EFFECTIVE WRENCH LENGTH EFFECTIVE WRENCH UNC~ (INCHES) 18 16 104- 12 10 MAXIMUM TORQUE (FOOT POUNDS) 111 106 100 93 84