BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL 2. Inst~ insulator a.etuator and micro switch on quadraJlt plate and secure with screws. lockwuhcn and nuts. 3. Adjust switch per puqnpb 6-63. 4. Innall cover on quadrant and secure with screws. 6-63. AdjumDCDt Of LaDdinr Gar W.miq Switch. a. Adjust the Iatldin, (CU' wamint micro switch located on the throttle shaft forwvd of the instrument panel by usinJ the foUowm, procedure: b. .When properly adjuRed the laDdinl JUt wU'Dint hom shouJd operate when the power is reduced below 10 to 12 inches of manifold prcuurc with the airpJme in 1lOrma.l descent and thc Jmdina pit retracted. 1. Stut and run up the eDJi.ne with the propeUer set: for hips RPM.

Reurd the throttle until approximately" inches of manifold pressure on the PA-2~laO. PA·2~2'0 and PA·2.... 260 and 5 inches of manifold pressure on the PA·24-400 is indicated above the desired iDflicbt pftlSlUft. 2. Mark the throttle shaft in some manner to that it can be reaamcd to the proper manifold pressure SCttinJ indicated dunn, the run-up liter the cqiDe bu been shUt down. 3. Place the airplane on jacks and retract the pu. Reurd the tbrotd.c to the location which pvc the desired manifold pressure indicuion. 4. Adjust switch on airplanes with Serial Nos. 2....1 to 24-4782 ind •• 24-4784 to 24-4803 incl.

and PA·24-400 by the followilll procedure, (a) With the bartery master switch on.lOoten the mountinJ screws or set screws on the micro switch mountiDI brackct and move the bracket fore aDd aft until the wanUna hom StartS to operate. Tighten the mountinc screws to secure the switcb auanbly. Tbc switch may &lIo be adjusced up or down to allow proper clcan.nce of the micro switch button on the throttle shaft. Adjust switch on airplanes with Serial NOl. 24004783. 24-4104 ud up. by the following procedure, (a) Remove the left aim cover from the throttle quadrant by removing attaching screws. (b) With the battery master switch on, loosen thc micro switch mounn ..

screws and move switch towvd actuator roller. on the throttle levu. until wamint hom startI to operate. Tighten mounting screws securing switch to quadrant plue and install cover. 6. Operate the throttle to uemain that the hom operates at the mark. and with warning hom operating, lower the ,ear to insure that the hom c:c:ucs to operate when the par is down and locked. 7. Remove the airplane from the jacks and fliJht tnt to iNure operation of the warning horn when the geu is up and power is reduced below the desired muifold pressure. If the hom fa.ils to operate at the required setting. mark the throttle shaft at the desired manifold prature and reset micro wamiDJ switch.

LANDING GEAR AND BRAKE SYSTEM ISSUED: 8/18/72 lK4