BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL 6-70. Aucmbly ADd Inmlladon Of No. Wheel. (Refer to Fipn: 6-24.) a. Ascertain that the bearing cup (3) in each wheel half is properly installed. Insull the tire and join the twO wheel halves. Install the throu,h bola (12) with the nuts (10) to the wbeel valve stem side. torque to the specification Jiven on the wheel ancI inflate the tire. Co InstalllfCue seals (6) and reaiDen (,) aDd SCcutC wic!l JCfCWS (8). d. Flex the fork moulft to allow for the iastalLacion of the wheel Uld spacer rubes. IDSCft the axle tube. fork caps and tic bolt. AdjuS[ the tie bolt nut to allOw the wbed to tum frft yet nOt fit lOOK on the axle. b. Lubricate and inscall bearinJ CODeS (4).

6-71. Ranov. And Da..mbly Of MaiD WhC. (CIenIand) a. Place tne airplane on jaw. (Refer to Jackiq. Section II.) b. Remove the four bolts joinirIC brake cyliDcicr and liniDI b&dr. piau UlCmbly and remove the brake assembly. c. On PA-24-180 and PA-24-Z'O airplanes. remove and dju'emble the wbeel as foUows (refer to Figure 6-2S): 1. Remove the axle tie rod nut. tic rod and axle plup. 2. Insert a 1.87' inch diameter tube into the fork and tap OUt the axle from the wheel assembly. 3. Insert a prying tool betWeen the side of the fork aaembly and wheel and apply enough prasure on the fork to allow the wheel to clear the fork aacmbly. 4. The wheel may be disulembled by using the foUowinl procedure:

(a) Deflate the tire and remove the sreuc seal retainer (S) by ranovinc the attaching screws (8). (b) Remove the baring cones (4). (c) Remove the bolu (12) securiDI the wheel halves qetbcr. (d) The baring cups (3) should be removed only for replaccment and may be removed by tapptng evenly from the inside. d. On PA·24-260 and PA-24-400 airplanes (C1evda.Dd) PA-Z4-Z00 and PA·Z4400, remove and disassemble the wheel as foUows (refer to Figure 6-Z6): 1. Remove the axle dUSt cover by removiDt artachinc screws. 2. Remove the cotter pin &adaxle nut and slide the wbeel off the axle. 3.

The wheel may be disassembled by dcflatinl the tire IDd removing the snap rinp (10) securing the srea.se seals (6) and seal retainers (S). 4-. Remove the bearinl cones (4) and remove the bolts (1) securing the wheel halves. S. The bearmg cups (3) should be removed only for replaccment and may be removed by t&pping evenly from the inside ot the wheel. LANDING GEAR AND BRAKE SYSTEM ISSUED: 8/18/12 lK7