PIPER COMANCHE SERV1CE MANUAL , OUTER WHEEL HALF 2. INNER WHEEL HALF 3 BEARING CUP 4. BEARING CONE 5. GREASE SEAL RETAINER 8. GPIEASE SEAl. FELT 7, BOLT 8. NUT t. WASHER 10. SNAP RING ". 8R~E DISC MINIMUM DISC f1oIICXNESS' MEA$UlltID AT3 POINTS TO GET AVEIl4GE DISC PIN MIN ",84-" s .~27 '184-UA S ,34.5 FIGURE &-26. MAIN WHEEL ASSEM8L Y (CLEVELAND) PA·Z4-210 PA·ZUOO e. On PA·24-180 ilnci PA-24-250 airplanes. Ulstal1 the whcc1 as foUows (Ref€.' to Figure 6-25): 1. The wheel may be installed by flexmt the fork enouch to aUow for installation of wheel "nd spacer tubes. 2. Insen the axle rube. fork caps mei tie bolt.
3, Adjust tie bolt nut to allow the whcc1 to tum freely yet not fit loose on the we. t. On PA·24-260 and PA·24-+00 airplanes. install the wheel as foUows(Refer to Figure 6·26): 1. Slide the wheelan the axle. 2. Tighten the axle nut to aU",w the wbeel to tum freely yet not fit loose on the axle. 3. SafetY the axle nut md inst&1l dust cover. g. InsuU the brake assembly by positionin' the bn.ke ImiDI back plates between the wheel lnci br.&ke disc and the brake cylinder on the torque plate. Insen the spacer block and shim berween the back plates and cylinder. and install thc four bolts to secure the usembly, If the brake line WII disconnected.
reecnneee the line and bleed the brakes, (Refer to plt1lhpb 6.Q.) 6-7~, Removal And DilaAcmbly Of MaiD Gar Wh.l. (Goodrich)PA·2MOO (Refer to Figure 6-27.) a. To remove the wheel assembly, remove the snap (12) securing the dust covet (11), remove the dust cover. b. Remove the cotter pin and axle nut. The wheel may be removed from the axle with the brake disc: rem.alnln, With the brake assembly, LANDING GEAR AND BRAK~ SY~TEM Revised: 9 10 79 lK9