BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANl"AL I _ BRAKE ASSEMBLY 2. BACK PlATE 3. BACK PlATE LINING ... RIVET s. SPACER e. PRESSURE PLATE LINING 7. PRESSURE PLATE I. CYUNDER PISTON 9. R[fRACTION CYLINDER 10. "0" RING 11.IOlT 12. BRAKE CYLINDER 13. BLEEDER SCREW 5 I". "0" RING II. lLEEDER BODY 18. 10lT 17. "0" RING I'. RETRACTION SLEEVE 1'. RETRACTION SPRING 20. WASHER 21. NUT 22.IOlT 23. WASHER 24. NUT 21, WASHER FIGl.:RE 6-28. BRAKE ASSEMBLY (CLEVELAND) PA-24-180 and PA-24-250. Serial Nos. 24·1 to 14·3295 6-80. Assembly And Instanation Of Wheel Brake Assembly. (Cleveland) PA-24-180 and PA·24·150. Serial Nos. 14-1 to 14-3195 I Refer to Figure 6-28.) a.

Lubricate the piston "0" rings with fluid MIL-H-S606 and install on pistons (8). Slide the pistons in cylinder housing ( '2) until flush with surface of housing. b. Slide the lining pressure plate (7) with retraction cylinder (9) onto the anchor bolts ( II) of the cylinder housing and install retraction sleeve (18). spring (19). washer (20) and adjusting nut (2'). c. Slide the cylinder housing assembly on the torque plate of the landing gear. d. Position the lining back plates (2) between the wheel and brake disc. Insert the spacer block (5) between the back plates and cylinder housing. and install the four bolts (22) to secure the assembly and safety. e. f.

Connect the brak.e line to the brake cylinder housing. Bleed the brake system as described in Paragraph 6-88. "NOTE Replacement brake linings should be conditioned as follows: I. For Cleveland brake nos. 30-12 and 3041. perform a minimum of six light pedal effort braking applications from 25 to 40 mph allowing the brake discs to partially cool between stops, 1. For Cleveland brake 1'\0. 30-23. perform three consecutive hard braking applications from 45-50 mph without allowing the brake discs to cool substantially between stops. REVISED: 4/10/81 lK12 LANDISG GEAR A~D BRAKE SYSTE:\1