BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANl'AL AUt 12 t. BOLT 2. WASHER 3. CYUNDER ASSEMBLY 4. "0" RING 5. PISTON e. INSULATOR IP... ·24--400 ONLY) 7 ..... CKING PLATE 8. UNING t. SP... CER 8 4 5 9 10. SHIP(P... ·24-400 ONLY) ". UNING 12. lACKING Itl.A TES 13. TORQUE Jl&.ATE 14. ANCHOR IOLT 1&. lLEEDER FfTTlNG 18. lLEEDER FfTTlNG CAP 17. WASHER tB. NUT FIGt:RE 6-29. BRAKE ASSEMBLY (CLEVELAND) PA-24-180 and PA-24-250. Serial Nos. 24-3296 and up, PA·24·260 and PA·24-400 e. Connect the brake line to the brake cylinder housing. f. Bleed the brake system as described in Paragraph 6-88. ~OTE Replacement brake linings should be conditioned as follows: I. For Cleveland brake nos. 30-12 and 30-41.

perform a min- imum of six light pedal effort braking applications from 25 to 40 mph allowing the brake discs to partially cool between stops. 2. For Cleveland brake So. 30-23. perform three consecutive hard braking applications from 45-50 mph without allowing the brake discs to cool substantially between stops. 6-84. Removal And Disassembly Of Wheel Brake Assembly. (Goodrich) PA-24-400 (Refer to Figure 6-30.) a. To remove the brake assembly first disconnect the brake line from the cylinder housing (7) at the line fitting. b. Remove the three bolts (15) joining the cylinder housing (7) to the torque plate (I) and remove the brake disc (4) and cylinder housing. c.

Remove the lining carrier (3) and insulator (2) from the torque plate and cylinder housing. d. The pistons (5) may be removed by injecting low air pressure in the cylinder fluid inlet and forcing the pistons from the housing. 6-1:\4a. Wear Limit Check. (Goodrich) This check is made with the parking brake set. (Refer to Figure to-30a. Any brake \\ hich shows this w orn condition should be overhauled within the next five landings. REVISED: 4/10/81 lK14 LANDING GEAR AND BRAKE SYSTЈ\1