BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

P'PEA COMANCHE SERVICE MANUAL 6-89. Brab ~uu:r CyliDder. (PA-1~180, PA·1~2'0, Scri&l Nol. 1~1 to 1~2174 incl. ud 2~2176 to 2~2298 incl.) 6-90. RaDG'ҐlIl Of Bnb Mula' CytiDder. .. Access to the brake cylinder is pined tbroup a removable ponion of the t100r board. loc:u:ed in frODt of the pilot's sat. b. Remove auacbiDI screws aDd roU back the carpet from iD froar of the seat. e. Remove the pad located to the lcfr of the DOle wheel bousm, by removing the aaacbm, screws. d. Disconnect the iDler supply line at the top of the cylinder aad dnin me fluid from the rtlCrvoir inro a suitable concamer. e.

DiscoMect the pressure line at the bottom of the cylinder aDd aDow the fluid to draiD from the cylindcr. f. DiscoDDeet the cylinder rod from the beUc:ruk by removiDI the coacr pin. washer and pin. ,. Remove the muter cyliodct from ia brackcr by removq the aftldliq cotter pin. washer and pin. 6-91. Dilulembly C1eMiDt. IlIIpCCdoa ADd Rcp. Of Ina M.-r CyliDder. (Refer to F ifurc 6-3'.) .. Disulcmble the DlUter cylinder by mnoviq the map riDt (3) at me tOp of the cylinder and c:xmctiDt the plunpr uscmbly from the bousiDC. b. Remove the pistOD bad (11). spriDJ pin (13) aDd btllbinl (') from the rod (7) by driviDg OUt the roU pin (9). c. Slide cap from piston rod. d.

Clean all puts in a suitable solvent. e. Replace aU wom puts. 6-92. A_mbIy Of Bnke Muter CyliDda'. (Refer to Fiprc 6-35.) a. Lubricate with hydraulic fluid aad insuJI the iaDer aad outer "0" rinp (4 and 6) on cap and slide assembly on pinon rod (7). b. Slide the bushinl (8) over the rod and the piston bad (11) over the SPrint pin (13). c. IlUUll "0" rm, (10) on end of piston rod. d. Inscrr the SPriDIpin (13) intOthe rod and secure with roU pin (9). e. Install spring (14) on end of spnn, pin. f. Slide the plunpr usembly intOthe cylinder housm, aDd scewe with snap ring (3). LANDING GEAR AND BRAKE SYSTEM ISSUED: 8/18172 lK20