PIPER COMANCHE SERVICE MANl'AL 7-48. In5t~lIation Of Harness. B~fore in.stalling harness o~ magneto. check mating surfaces for clcanlin. Spray entire face of grommet with a lightcoat of Plastic Mold Spray. SM-O-O-TH Silicone Spray equivalent. This will prevent harness grommet from sticking to magneto distributor block. . a. Place the harness terminal plate on the magneto and tighten nuts around the plate alternate" to seat cover squarely on magneto. Torque screws to 18 to 22 inch pounds. . b. Route ignition wires to their respective cylinders. c. Clamp the harness assembly in position and replace the engine baffle plate. d. Connect the leads to the spark plugs. 7-49. Spark Plugs. 7-50.
Removal Of Spark Plugs. a. Loosen the coupling nut on the harness lead and remove the terminal insulator from the spark plug barrel well. ~OTE When withdrawing the ignition cable lead connection from the plug. care must be taken to pull the lead straight out and in line with the center line of the plug barrel: otherwise. a side load will be applied which frequently results in damage to the barrel insulator and connector. If the lead cannot be removed easily in this manner. the resisting contact between the neoprene collar and the barrel insulator will be broken by a rotary twisting of the collar. Amid undue distortion of the collar and possible side loading of the barrel insulator. b.
Remove the spark plug from the engine. In the course of engine operation. carbon and other com bustion products will be deposited on the end of the spark plug and will penetrate the lower threads to some degree. As a result. greater torque is frequently required for removing a plug than for its installation. Accordingly. the torque limitations given do not apply to plug removal and sufficient torque must be used to unscrew the plug. The higher torque in removal is not as detrimental as in installation. since it cannot stretch the threaded section. It does. however. impose a shearing load on this section and may. if sufficiently severe, produce a failure in this location.
!\OTE Torque indicating handle should not be used for spark plug removal because of the greater torque requirement. c. Place spark plugs in a tray that will identify their position in the engine as soon as they are removed. ISS[ED: 8/18/72 2B16 POWER PlA.