TABLE \'11-111. TROVBLESHOOTI~G CHART (P";GI1I\E) (cont) PIPER COMANCHE SERVICE MANUAL PO\\ER PL 2B24 ISSlED.8/18/72 1 ~. Trouble Cause Remedy High oil temperature. Insufficient air cooling. Insufficient oil supply. Clogged oil lines or screens. Failing or failed bearing. Defective thermostats. Defective temperature gauge. Excessive blow-by, Improper engine operation. Check air inlet and outlet deformation or obstruction. Fill oil sump to proper level. Remove and clean oil screens, Examine sump for metal particles and. if found. overhaul engine. Replace. Replace gauge. Usually caused by weak or stuck rings. Overhaul. Check entire engine. Excessive oil con- sumption.
Failing or failed bearing. Worn or broken piston rings. Incorrect installation of piston rings. External oil leakage. Leakage through engine fuel pump vent. Engine breather or vacuum pump breather. Check sump for metal particles and. if found. overhaul of engine is indicated. Install new rings. Install new rings. • Check engine carefully for leaking gaskets. "0" rings or sand holes. Replace fuel pump "0" ring. Check engine and overhaul or replace pump. Inaccurate pressure readings. Cold weather. In extremely cold weather oil pressure readings up to 100 pounds do not necessarily indicate malfunctioning. Overprirning. Cold weather. Open throttle and unload engine. Inaccurate pressure readings.
Cold weather. High or low pressure readings due to extremelv cold weat her are not necessarilv a mal- function. Small and long oil lines will not transfer pres- sure readings accurately until engine is quite warm.