BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMAl\4CHE SERVICE MANl'AL POWER PLA:"T PA-24-150 A:"D PA-24-260 SECTIO:" VilA 7A- L Introduction. This section covers power plants used in the PA~24~250 and PA-24-2flO and i ... comprised of instructions for the removal, minor repair. service and installation of the engine cowlinc. propeller. propeller governor. engine. engine shock mounts. induction system. ignition ... ~ ... tern an~d lubrication system. iA-2, Description. The PA-24-250 and PA-14~260 Comanche is powered bv an Avco-Lvcominz enuine of either 250 or 260 horsepower. (Refer to Power Plant Specifications in Table II-\.) Engines are ().5~1i serie ... or 10-540 serie ... which are six cylinder direct drive. wet sump.

horizontally opposed, air-cooled. and are designed to operate on 91 90 (minimum) octane aviation grade fue\. CO\\ ling completely encloses the engine and consists of an upper and lower section. Side pa nct- lift up to allow access to the engine. The propeller may be a constant speed McCauley or Hartzell unit controlled by a gov ernor mounted on the engine supplying oil through the propeller shaft at various pressures. Oil pressure from the governor moves the blades into high pitch (reduced RPM) and centrifugal twisting moment of the blades tend to move them into 10\\ pitch (high RPM) in the absence of governor oil pressure.

The induction system consists of a wet type air filter on the early models or a dr~ type air filter on the later models and a MA-4-5 Marvel-Schebler carburetor or a Bendix fuel injection unit. The engines are normally aspirated with no restrictions on maximum power output. Bendix Scintilla S6l:"-20 series and S6L:"-200 series magnetos are installed with their associated components. The Sel, ~-20 series magnetos incorporate a single breaker and an impulse coupling inst. on the left magneto. The Sf'll~-200 series magneto system consists of a single contact magneto on the side of the engine and a dual contact magneto on the left. to obtain the retard spark necessary for starting.

A starting \ ibrator. magneto switches and starter switch complete the system. In addition to the previously mentioned components. each engine is furnished with a 12-\olt starter. a I ~-\ olt. ~5-ampere or 50-ampere generator or a 70-ampere alternator: a vacuum pump drive and fuel pump. The lubrication system is of the pressure wet sump type. The oil pump. which is located in the accessory housing. draws oil through a drilled passage leading from the oil suction screen located in the sump. The oil from the pump then enters a drilled passage in the accessory housing. which feeds the oil to a threaded connection on the rear face of the accessory housing.

where a flexible line leads the oil to the external oil cooler. Pressure oil from the cooler returns to a second threaded connection on the accessory housing from which point a drilled passage conducts oil to the oil pressure screen or filter. In the event that cold oil or an obstruction should restrict the oil flow to the cooler. an oil by-pass valve is prov ided to pass the oil directly from the oil pump to the oil pressure screen or filter. The oil pressure screen or filter element. located on the accessory housing is provided as a means to filter from the oil any solid particles that may have passed through the suction screen in the sump.

After being filtered in the pressure screen or filter. the oil is fed through a drilled passage to the oil pressure relief valve. located in the upper right side of the crankcase in front of the accessory housing. ISS rED: 8/18/72 2C4 POWER Pl..