PIPER COMANCHE SERVICE MANUAL iA·23. Propeller Goventar. 7A·24. Rcmoval Of Propellcr Governor. I. Lift the left side panel of the engine cowling. b. Disconnect control cable from governor control ann. c. Remove the governor mounting stud nua. It will be necessary to raise the ,overnor as the nuts Ire beinl removed before the nua can be completely removed. d. Remove the mounting guket. If the governor is to be removed for a considerable len,m of time Ind mother unit is not substitutcd. it is advisable to covet the mountin. p,ad to prevent darnqe caused by foreign marter. 7 A'25. Inlta1Jation Of PropcUa' Govcmor. a.
Clean the mounM, pad thoroughly making very ccruin that there are no forelgn particles in the recess around die drive shaft. b. Place the governor mounting lasket in position with the raised po"ion of the screen facing away from the elt(ine. c. Alip the splines on the governor shaft·with the eriline drive Ind slidc the governor in position. d. Raise governor off mounting pad enough to install washers IJSd Start mounting nuts. Torque nuts evenly. e. Connect the control cable end to the governor control ann. E- Adjust governor control per p&taJt'lph i A·26 or 7A-27. i A-26. Adjustment Of Propeller Govcmor. (Woodward) (PA-24-250) (Refer to Figure i A·5.) I.
Start the engme in accordance with the directions liven in Owner's Operating .\\an'.1l1 and'allow to warm up. b. Push the "PROPELLER" cockpit control as far forward as it will go. At this position the governor sp"d :Ldjusting control lever will be against the hi-rpm fine adjulti"' screw. c. Observe engine speed. Adjust the governor speed by means of the fane ~d.bmnent screw for 25iS rpm. To do this. release the f&Stenen and lift the sidc e"linc cowling. Relcase the speed control lever damp screw ( ... ) and move the lever relative to the covet serrations.
Once serration movement m a clockwise direction produces a decrease in spced of 100 rpm; one sern.tion counter increases the speed 100 rpm. Onc revolunon of the hi-rpm fine adjllStment screw in a dOl:kwiscdirecticn decreases eng-lne speed 2S rpm. counter-clockwise roration increases engine speed 25 rpm. for each revolution of the screw. d. After SCttlnj the engine rpm at 2575. tilhten the l:ontrol lever clamping screw. and run the self-locking nut on the fine adjustment screw against the stOp ri"l projection. Then safery,wlre the head of the screw to the projection. e. Fastcn cowling on both sides. POWER PLANT ISSUED: 8/18172 2 C15