BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL CAL'TtON Do not exceed the above air pressure u internal aam...,e to cbe injector may result. d. After filling wicb prnervative oil. the injeC'ror shou1cl be protected from dust and din and given such protection against moisture as climatic conditions at cbe point of st0tlle require. In most cases. storing the unit in a dry area will be sufficient. e. If the unit is to be stored near or shipped over salt water, the followm, prel:&utions should be observed: 1. Spray the exterior of the injector with an approved preservative oil. 2. Pack in a dustproof container. WftP the containCf with moisture and vapor-proof material and seal.

Pack the wrapped unit In a suiuble shippinB ease, Pack a one-half pound baa of silie:!. gcl aysuls In the dustproof container with InJcctor. The baa must not touch the injector. CAUTION Extreme caution should be exercised when handliftr or worltinl around the Injector to prevent oil or fucl from entering the air sections of the injector. As explained previously. 4amate to the air diaphrapn will result. Fluid can easily enter the air section of cbe injector throlllh the impact tubes or the annular Il'oove around the venturi. For this reason, a protective plate should be installed on the seoop mountiDJ fIanJC when perfonnin, routine maintenance on the e"line.

such as wuhin( down the engine and air scoop. serviciDJ the air ruter (surplus oil on the clement). or when injecting preservative intO the eft(ine prior to scoriftl or Shipping. iA-S9. Preparation Of Fucllnjector For Service. Fuel Injectors that have been prepared for storlie should undergo the followmg procedures before being placed in service. a. Remove and clean the fuei inlet strainer UKmbly and reinstall. b. Inject clean fuel intO the fuel inlet connection with the fuel outlets uncapped until clean fuel flows from the outlets. Do not exceed is psi inlet pressure. i .. ~~O. Installation Of FucllnjeC'tor. I. Secure lir box with gasket to the injeC'rorusing cap bolts and washers.

SafetY with lock wire. b. Install gUKet and injector umt on the bottom of the sump and seC\lfC with wuhers. nuts and pal locknuts. c. Connecr the fuel lines to the injector unit. d. Connect the throttle and mixture eenerct cables at the injector unit. e. Install engine cowlift! pcr pamgnph iA-7 or 7A·l0. POWER PLANT ISSUED: 8/18n2 2 015