PIPER COMANCHE SERVICE MANUAL UI JP"!I..-------- TIMING MARKS FIGURE 7A·21. ENGINE TIMING MARKS g. Turn on the timing licht SVritc:b. h. Rotate the magneto housing in the direction of the mapet roution a few dqrees until the timing light comes on. Then slowly tum macncto in opposite directioa until the timing IiIbt goes OUt. Secure the magneto housing in this position. NOTE Some timing lighu operate the opposite of the one mentioned. i. Rotate the crankshaft opposite norma! rotation wuil it is approximately 3S dqrecs BTC on compression stroke So. one cylinder.
NOTE The crankshaft should not be rotated more than 10 dqrecs in direction opposite normal rotation from the %5 dqrce BTe as the pawL on the impulse couplinl (.Z1 macnetos) will enpp with the stOp pin and late tuning will be indicated throUlh the impulse coupling mechanism. If this should happen. rotate crankshaft in normal direction until sharp click is heard; this will indicate that the impubc couplinJ has pused through firing position. Tum crankshaft in direction opposite normal rotation to approximately 35 dqrees ~TC and proceed with riminJ check. POWER PLANT REVISED: 4/10/81 2 024