BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MA~l':\L With the engine thoroughly warmed .up and running at a ma.ximum of 1200 ~P~. observe the reae on the 011 pressure gauge. If the pressure IS above 90 pSI. stop engine. loosen the adjusting locknut: and bac \)1'1' the adjusting screw one or two full turns. Tighten locknut and retest. If pressure is too low turn adiustinu screw further into the relief valve plug. thereby increasing the tension on the relief valve spring. When th~ valve has been satisfactorily adjusted. tighten the locknut and lock wire the crown nut to the drilled car projecting (rom the valve mounting boss. 7A-~5. Oil Screen. The oil screens are the pressure screen.

located in a dome shaped housing. above and between the magnetos and the suction screen located in the lower aft section of the sump. These screens should be cleaned at each oil change to removeany accumulation of sludge and to examine for metal filings or chips. If metal particles are found in the oil screens. the engine should be examined for internal darnge. a. To remove the pressure screen. remove oil temperature electrical lead or the temperature bulb and the cap screws securing the housing. :\ote the location of the screws as the round fillister head screw. if installed. must be returned to upper right corner of the housing.

If the fillister head screw is not reinstalled in the same hole from which it was removed. it is possible to crack the mounting flange of the vacuum pump. b. With the housing and screen removed. clean and inspect both items. check the mating surface \)1' the housing and accessory case for gasket panicles. c. Insert the screw into the housing so that the screw fits flush with the housing base. l'sing a new gasket. secure the housing to its mounting pad and torque cap screws to 75 inch pounds. d. The suction screen is removed from the sump by removing the hex head plug at the lower aft part of the sump. Clean and inspect the screen and gasket. replace the gasket if over compressed or damaged.

Insert the screen fully into the sump. install gasket and plug. Safety the plug. 7.-\-Ro. Oil Cooler. a. When conducting a routine engine inspection. the oil cootens). lines and fittings should be chcc for the following: I. Oil cooler line attachments should be examined to be certain that all are tight and there is no indication of eros-threading. (See C for oil line torque.) , Oil lines must have adequate clearance and be properly aligned. J. Oil line supports should be tight. properly positioned and if worn should be replaced. 4. Oil cooler should be checked for leakage or distorted cells. 5. Cooling fins should be clean and undamaged. b. During each engine overhaul.

at indications of high oil temperatures or during a 500 hour inspection. the oil cooler should be removed. cleaned and checked for damaged fins and cells. When replacing the cooler. properly align and do not over tighten the mounting bolts so that the cooler would be damaged. While the oil cooler is removed. the oil lines should be disconnected and flushed. c. If it is found that oil is leaking around the line compression nuts. check that the nuts are tightened to 125 inch pound wet torque or the nut may be backed off. retightened finger tight. plus a J 4 turn. Do not over torque. d. Should oil continue to leak. it may be necessary to replace the seal rings.

Also remove the compression nuts and inspect the line ends in the area of the swagged ferrules for collapsed tubing. This condition may be observed by looking into the tubing ends. Should the tubing show indications that it i, collapsed and new seal rings and proper torque does not stop leakage. the oil lines should be replaced. Also m..pect the surfaces of the mating fittings for damage. POWER PL.~' ISSl"ED: 8/18/72 2E6