PIPER COMANCHE SERVICE MANUAL L Position the spiJmer buJkhead (7) apiftIc the swter rin, Jat suPPOrt (8) so thar on arrow lines up with the TCI on the front face of the support. 7B·IO. lua1Wioa Of PropcUcr. (Refer to Fipre 78·1.) b. Secure the spinner bulkhad to the saner rina gear suppon: with 12 bola. IUlCI aDd 24 washen. (One under the bolt head and one wuler cadi nut.) CaftfuUy tiptCD nuts uniformly to torque limits shown in Table VIJ.l. . c. Clean the propdIcr aDd CDJine flutes. d. Observe the starter rinI par to make JUre it is mounted properly on the cnJiae amkshaft fIante. The cnakshaft fIanp is swnped with III "0" mark uad the saner riftJ par is likewise identified by an "0" mark.
Upon iDsuJ1ation - of the stamf riJII aar. the mariUnp sball be ma:ed to insure proper installation. c. Install "0" rint (6) and shim (5) on the eaFnc sbat't. CAUTION it is absolutely CSSCDtial that shim (5) be insta11cd u failure to do so may rault in f&i1urc of the mournin, bola due to reLative movement of the two a&fIICS. f. Raise the propeUer into posicion with the enpc.nd slide the propeUer onto thc propeUer mountinJ bushiDp. ,. Install the mountiJlt bola (4) in the propeUerhub and secure propeller to engifte flange. h. Torque bola to specification liven in Table VIlB·1 and safety. i. Check blade track per pancnPh 78·11. j. Install propeUcrspinner and secure to bulkhead with screws.
7B-l1. Ba.Ie Track. Blade track is the ability of one blade tip to foUow the other. while routing. in almost the same plane. Excessive difference in blade traCk • more than .0625 inch· may be an indication of bent blades or improper propeller installuion. Check blade u foUoWl: a. With thc cnJine shut down and blades vertical. secure to the aircraft a smooth board just under tbe tip of the lower blade. Move the tip fore and aft throup iu fuU "bladc1hakc" m.vel. makin. small marles with a pencil at each position. Then center the tip between these marks and scribe a line on the board for the full width of the tip. b. CarcfuUy route propcUcr by hand to brinl the opposite blade down.
Center the tip and scribe a penc:illinc u before and check that lines arc not lCparated morc than .0625 inch. c. Propellcn haviDi excess blade m.ck should be removed and inspected for bent blades or for partS of sheared "0" rinI. or forcip particles. which have lodpd bctwccn hub and cnnkshaft mountinJ faces. Bent blades will require repair and overhaul of uscmbly. 2 E24 POWER PLANT ISSUED: BI1an2