PIPER COMA~CHE SERVICE MA:'\itAL I. ~_ AOIII$·'.' SCIIIYf Z. 1.0CII "liT J. I:O"TIIOI. All'" CO"TlIOI. ."UI. S. IClIlYf A'II"'II.' ..R-I 2. Propeller Governor. FIGl'RE 7B-3. PROPELLER GOVER~OR ADJl'ST:\lEl'iT POI~TS "8-1~. Removal Of Propeller Governor. J. Lift the left side panel of the engine cowling. b. Disconnect control cable from governor control arm. c. Remove the governor mounting stud nuts. It will be necessary to raise the governor as the nuts are being: rernov ed before the nuts can be completely removed. d. Remove the mounting gasket. If the governor is to be removed for a considerable length of time and another unit is not substituted.
it is advisable to cover the mounting pad to prevent damage caused b~ foreign matter. 7B~14. Installation Of Propeller Governor. a. Clean the mounting pad thoroughly making verv certain that there are no foreign particles in the recess around the drive shaft. b. Place the governor mounting gasket in position with the raised portion of the screen facing away from the cnuine. c. .-'\iign the splines on the governor shaft with the engine drive and slide the governor in position, d. Raise governor off mounting pad enough to install washers and start mounting nuts. Torque nuts evenlv. ISSt'ED: 8/18/72 2F2 POWER PL\'T