PIPER COMANCHE SERVICE MANUAL e. Connect the control cable end to the governor control arm. f. Adjust gov~rnor p~r paragraph 7B-15. g. Fasten the cowling on both sides, 7B-15. Adjustment Of PropeUcr Governor. (Refer to Figure 7B-3.) a. Start the engine in accordance with the directions given in the Owner's Flight Manual and allow to wumup. b. Push the "PROPELLER" cockpit control as fu forward as it will go. At this position the governor speed adjusting conrrol lever will be apinst the hi-rpm fine adjusting screw. c. Observe engine speed. Adjust the governor by means of the fine adjustment screw for 2650 rpm. To do this. release the fasteners and lift the side engine cowling.
loosen the fine adjustment screw locknut and turn the hi-rpm fine adjustment screw in a clockwise direction to decrease engine speed and a counterclockwise rotation to increase engine speed. One revolution of the fine adjustment screw increases or decreases the propeller speed approximately 15 RPM. d. After setting the engine rpm at 2650, run the self-locking nut on the flne adjustment screw against the base projection to lock. e. Pull the "PROPELLER" cockpit control aft to the low RPM position. f. Observe engine speed. Set to 1550 rpm either by threading the fitting at the governor control arm onto the cable.
or by turning it in the direction tending to remove the fitting from the cable, depending on whether it is required to decrease or increase engine speed, respectively. It will be necessary, of course, prior to adjusting, to remove the self·locking nut and disconnect it from the governor control arm and to release the fitting locknut. g. Reconnect cable to governor control arm, tighten fining locknut. and recheck engine by moving cockpit control in and out of the appropriate settings. h. Fasten the cowling on both sides. 7B-16. Removal Of Enpne. 7B-17. Installation of Engine. NOTE Refer to latest lycoming Service Instruction So. 1241. 7B·IS. Engine Shock Mounts.
Replacement of engine shock mounts. Refer to Figure 7B~ for the proper arrangement of engine shock mount assemblies. The top shocks are assembled so the silver colored'shock is aft and the gold colored shock is forward. The lower shock mounts are installed opposite of the top shock mounts. Torque shock mount bolts to 450 to 500 in. lbs, and safety. REVISED: 4/10/81 POWER PLANT 2F5