PIPER COMANCHE SERVICE MANUAL ~. Remove and clcsn the injector fuel inlet strainer It me fllSt 25 hour inspection and each 50 hour inspection thernfter. Dunaged strainer "0" rings should be replaced. Torque strainer to 65-70 inch pounds. b. Tests prove that psoline which becomes sale due to proloapd uorqe absorb. oxyget rapidly. This stale oxidized psoline acquires a very distinctive odor similar to vunish, causes rapid deterioration of synthetic rubber parts. and aha fonns I gummy deposit on the internal metal partS. This condition. however. docs not occur durinl normal operation of the injector where fresh fuel is being consundy c1rculated. J.
Check chronle and mixture control rods and levc:n for ti,htnCSl and lock. 78·26. Lubricalioa Of Fucllnjectot. a. There: is very linle need for lubrication of the: injector in the field bftWecn rcpw overhauls. Huwc:ver, the clevis pins used in connection with the throttle: and manual mixcure conrrollevcn should be: checked for frcedom of movement and lubricated, if necessary. b. Place a drop of enpne grade oil on the end of the throttle shaft in such a manner that it can work into the throttle shaft bushings. ;'8-27. Removal Of Fuel Injector. a. Remove the bottom cowlin,. (Refer to plf&lnPh 78-4.) b. Remove air intake hose: from filter box. c.
Release the fasteners around the air box lAd remove from back plate. d. Remove nuts and bolts from clamp assembly at the injector unit. e. Remove safety wire and screws from air box back plate. f. Remove back plate and clamp assembly from injector unit. g. Disconnect throttle and mixcure control cables from injector unit. h. Disconnect fuc:llincs from injector unit. I. Remove pal locknuts and nuts from injector unit mounting scuds. J. Remove fuel injector from mounting pad. 78·28. Preparation Of Fuel Injector For Shippinl' Any unit taken OUt of service. or units being returned for overhaul. must be rlusheQ with preserving oil (Specification MIL~-6081.
Grade 1010), using the follOWing procedures: a. Remove plup and dnin all fuel from the injector. If available. apply 10 to 15 psi air pressure to the fuel inlet until all fuel is dischatJed from the injector. b. Replace plugs and apply flushing oil filtered through a lO-micron filter at 13-1S psi to the Injector fuel inlet until oil is discharged from the euuee. c. Replace fuel Inlet shipping plug. CAUTION Do not exceed the above air pressure as ineernal damage to the injector may result, POWER PLANT ISSUED: 8/18/72 2 F7