BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL ... 0 PAINTED LINE ON DISTRIBUTOR BLOCK FIGURE 78·12. ALIGNMENT OF CAM IN INSPECTION HOLE NOTE Be sure the Timing Pointer does not move on the rotor shaft after it has been aligned with the full register position timing mark. f. Turn rotor shaft in direction of rotation until timing line of Timing Pointer is directly over timing mark for main contact assembly point opening. Tighten adjusting knob so rotor cannot tum but not tight enough to cause damage to drive end bearing. g. Install main contact assembly and tighten pivot screw. Turn cam until files notch on cam is approximately in center of hole marked "T".

(Refer to Figure 78-12.) Then continue turning cam in direction of rotation until cam follower of main eeneaer assembly is on high point of cam lobe. Set contact clearance to 0.019 + 0.001. Torque securing screws to 20·25 lb. in. and pivot screw to 12·15 lb. in. h. Turn cam until notch on cam flange is approximately aligned with screw hole nearest hole marked "T". Connect the 11-851 Timing Light. or equivalent. across main contact assembly. Tum cam in direction of rotation slowly until timing light goes out (contact points open). While holding cam in this position. tighten cam securing nut. Be sure cam does not move while tightening nut. Torque nut to 20-25 lb. in.

Be sure timing light is still out. i. Check that the Timing Pointer is over timing mark for main contact assembly point opening. Loosen adjusting knob of the Rotor Holding Tool and tum shaft until Timing Pointer is aligned with scribed line for rerard contact assembly point opening. Tighten adjusting knob of Holding Tool enough to hold rotor in this position. j. Install retard contact assembly and tighten pivot screw. Using the 11-851 Timing Light, set contact points to open at this point. Torque securing screws to 20·25 lb. in. and pivot screw to 12·15 lb. in. Loosen adjusting knob of Holding Tool.

Turn rotor in direction of rotation until cam follower of retard contact assembly is on high point of cam lobe. Check contact clearance. It must be from 0.018 to 0.023 inch. If clearance does not fall within limits. replace the ~ontact assembly. k. Apply a stripe of glyptal, any color, across cam retaining nut and distributor rotor mounting surface. POWER PLANT ISSUED: 8/18/72 2 F16