BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

a. Turn the engine crankshaft t,o numbe.r one cylinder ful,l advance firi~g ~osition. (Refer to Fig. 7B-().) Install the magneto on the engine and tighten the mounting clamps sufficiently to hold magneto if. position and yet allow it to be rotated. PIPER COMA!"olCHE SERVICE ~A~l'AL Extreme caution must be exercised when aligning one of the painted lines on the distributor finger With the painted line on distributor block. After magneto has been installed on engine. check through opening marked "1'" to see that these marks (lines) are still properly aligned. Cam lobes are so close together that ifthe magneto isturned only slightly it will be possible to time magneto on the WRO:\G CYLI:\ DER.

It could be on the ~EXT cylinder in firing order or it could be on PREvlOl'S cylinder in firing order. 10-710 series engine firing order is 1-5-8-)-2-6-7-4. C. If the timing light is out (battery operated models). rotate the magneto housing in direction of its magneto rotation a few degrees until light comes on. Then turn slowly in opposite direction until light goes out. Secure the magneto in this position. b. Connect a timing light to switch wire (shielded capacitor wire) and to a good ground on engine. :\OTE The magnetic force in the S-700 series magnetos tends to act in the direction in which the rotor is turned during the timing operation.

This causes the backlash in the magneto drive gears to accumulate in the same direction. Consequently. as the magneto isbeing timed. the backlash can be overlooked and result in a timing error as much as 6 to to\ degrees. To eliminate this possibility. insert a small screwdriver through the "T" marked opening and engage the painted rotor timing groove. (The painted lines on the distributor block and finger w ill be found in approximate alignrnent.) With a light force depress the screwdriver. moving the rotor in a counterclockwise direction. as viewed from the rear. sufficientlv to remove anv backlash whileat the same time.

rotate the magneto back and forth in both directions until the breaker points just begin to open. as indicated by the timing light. If inaccessability to the "I'" marked hole prevents it from being used for holding out backlash. the magneto distributor block must be removed and the magneto rotor utilized for this purpose. d. Repeat this procedure for the other magneto using another timing light. .:. After both magnetos have been satisfactorily timed. leave the timing light wires connected and recheck timing as previously described to make certain that both magnetos are set to tire simultaneously. If ISSl"ED: 8/18/72 2F18 POWER PLA:"T