BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL 7C-18. ERpne. 7C.I'. Removal of [nline. PA-24·260 (Turbocharged) (Refer to Figure 7C·4.) a. Tum off aU cockpit switches and disconnect the battery JfOund cable at the bactCry. b. Move the fuel control lever located on the fuR. floor between the twO front seats to the OFF position. c. Remove engine cowlin•. (Refer to panpph 7C-S.) d. Dnin engine oil if desired. e. Remove propeUer. (Refer to pUIIftPh 7C-9.) f. Disconnect cabin beat. fuel pump and oil cooler air duets. NOTE Where a question may ariJe as where to eeeeaaeee bose. line or wire. the item at. the scparation should be identified (uqed> to facilitacc installation. Open fuel. oil.

vacuum lines and fininp should be covered to prevent contamination. ,. Disconnect the manuold pressure line. No.6 cylinder and remove clamp securing it to engine mOWlt. h. Disconnect turbo oil supply lines at the enJine xcusory hOUM,. I. Disconnect mqncco up" leads. mard lead (left magncco only) and shicldint Jl'ounds from mqnetos. J. Disconnect tachometer drive cable and oil temperature lead from the engine accessory housing. k. Disconnect vacuum hose at vacuum pump. 1. Disconnect oil cooler oudet hose at eriline accessory housm, and inlet hose at oil cooler. m. Disconnect engine breather from enline. n. Disconnect exhaust gu and cylinder temperature leads from So.

6 cylinder c:'Chaust stack and cylinder head. o. Disconnect fuel pump inlet line and drain hose at fU'CWall. p. Disconnect fuel pressure. oil pressure and fuel flow meter vent lines. q. Disconnect the stuter cable at the starter. remove cable clamps at the left side of the engine and enpne mount. and draw cable aft to the firewall. r. Disconnect altemator leads at alternator. remove clamps securirlJ wires to engine and draw them aft to the firewall. s. Disconnect alternate air door concrol cable. t, Disconnect throttle. mi.'tt\1fC and propeller governor centrol cables and remove clamps secunng them to engine. u. Remove tail pipe braces.

v, Disconnect exhaust wute gate concrol cables and remove clamps securing them to the tail pipes. \Y. Disconnect spark plUJleads from left bottom spark plup. x, Remove bonding scraps from engIne at sides of mount. y. Loosen matneto mounanl nuts and rOtate magnccos to clear engine mount. POWER PLANT REVISED: 4/10/81 2 817