PIPER COMANCHE SERViCE MANUAL Ground Boosted or Ground Turbocharged These phrases indicate that the engine depends on a certain amount. turbocharging at sea level to produce the advertised horsepower. An engine that is so designed will usually include a lower compression ratio to avoid detonation. Deck Pressure The pressure measured in the area downstream of the turbo compressor discharge and upstream of the engine throttle valve. This should not be confused with manifold pressure. Manifold Pressure The pressure measured downstream ofthe engine throttle valve and is almost directly proportioned to the engine power output.
Norrnalizing If a turbocharger system is used only to regain power losses caused by decreased air pressure of high altitude. it is considered that the engine has been "normalized". Overboost An overboost condition means that manifold pressure is exceeding the limits at which the engine was tested and FAA certified and can be detrimental to the life and performance of the engine. Overboost can be caused by malfunctioning controllers or improperly operating wastegate in the automatic system or by pilot error in a manual controlled system. Refer to latest copy of Lycoming Service Bulletin No. 369.
Overshoot Overshoot is a condition of the automatic controls not having the ability to respond quickly enough to check the inertia of the turbocharger speed increase with rapid engine throttle advance. Overshoot differs from over boost in t. the high manifold pressure lasts only for a few seconds. This condition c usually be overcome by smooth throttle advance. A good method fOI advancing the throttle is a follows. After allowing the engine oil to warm up to approximately 140 0 F. advance the throttle to 28" to 30" manifold pressure. hesitate 1to 3 seconds and continue advancing to full throttle slow and easy. This will eliminate any overshoot due to turbocharger inertia.
Bootstrapping This is a term used in conjunction with turbo machinery. If you were to take all the air coming from a turbocharger compressor and duct it directly back into the turbine of the turbocharger. it would be called a bootstrap system and if no losses were encountered. it would theoretically run continuously. It would also be very unstable because iffor some reason the turbo speed would change. the compressor would pump more air to drive the turbine faster, etc. A turbo- charged engine above critical altitude (wastegate closed) is similar to the example mentioned above, except now there is an engine placed between the compressor discharge and turbine inlet.
Slight system changes caused the exhaust gas to change slightly. which causes the turbine speed to change slightly, which causes the compressor air to the engine to change slightly. which in turn again affects the exhaust gas. etc. Critical Altitude A turbocharged position engine's wastegate will be in a partially open position at sea level. As the aircraft isflown to higher altitude (lower ambient pressures) the wastegate closes gradually to maintain the preselected manifold pressure. At the point where the wastegate reaches its full closed position. the preselected manifold pressure will start to drop and this is considered critical altitude. POWER PLANT 2G20 ADDED: 4/10/81