BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL k. ConneCt turbochU'Jft' outlet staek brace. l. Connect wute pte control able and clamp to turbocbUJft oudet mck. m. Aajust contrOl cable rod SO swaged area is recaICa intO able attadunent clamp with wUte pce in the dosed position. n. Connccr ~ompralOr oudet aad inler ductS and secure with clamps. When inIta11inI the rilht Ntbocharpr. position air plenum on N1'bodtUJU and RCIlfe to compressor inlet with cJamp and co turbochU'JCt lu, with bolt. wuber and Qut. Connect inlet and outlet air chacts to air plenum and secure with clamps. o. AdjuSt tucbocharpn co eftliDe. (Refer co panppb 1C-Z'.) p. Retorque all V band clamps after run in. q. Install eDJinc cowq.

(Refer to paftlnpb 1C-7.) iC·25. AdjUftlllent OfTurbochlIrpn. :L Remove bonom enJine cowL b. Adjust wUte pte control cable rods so both WUte pta close at the same rime and swaged area is recessed inco cable attachment clamp. c. Start engine with turbochU'Jft1 "off" and aUow CJ1IiMS co warm up. d. Run eft!ine at fun throttle (2700 RPM) aad acivaDce rurbochupr control lever until manifold pressure reads one half inch of mercury less than the field barometric ptaalre. e. Stop eftline. f. Without moviftl the wute ,ace control cable adjust the coftcrollever back to its stop. g. Safety all control cable connections and install quadrant trim panel. h. Install bonom CftIine cowl. iC·26.

OverbeaR Pteuwc Rc1icf Valve. The ovcrboost prasure relief valve sensa deck pressure directly against the valve face which is hela in a dosed posieioQ by action of the canica.! sprint and aneroia bellows. The valve face will remain seated under all conditions of 1l0rmal deck manifold presl\lrcs. In tbe event chat overboost docs occur. The relief valve will not permit deCk pressure and thereby manifold ?tessure to build up co marc than 3.'" HIA in cxcess of normal maximum allo.... ble prCSll.1res. iC·27. Removal Of Pralun RcJicf Valve. a. Remove bottom enpne cowl. (Refer to pltafnpb 7C-'.) b. Remove bolrs sccurin, relief valve to compressor dischUJc box. c.

Cap compressor dischUJe box to ptўVўnt conumination. iC·l8. Cleanine And Inspection Of PmIwe ReUd Valve. a, Ciean vaive ana seat areas with saivent or air. b. Inspect valve aetion by pushiftJ on pressure side, to detcrminc that beUows or spring are not resmeted. c. Inspect valve and seat for wear or damage. d. Inspcct "0" tlng guket for damace or deterioration. POWER PLANT ISSUED: 8/18/72 2G24