BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

P'PEA COMANCHE SEAV'CE MANUAL 1C·34A. Indicator, Mixture Control (!GT). The mixture control indicator is to aid the pilot in seJectinl the most economical fuel-air mixture for cruisinl Oisht at a power setting of 75% or less. It is a seosin, device to monitor tbe fuel __ it mixture lavinl the enaine cyiinden. {f. after checkinl with the trouble-sbootin, chan. tbe indicator is (ound to be defective it sbould be replaced. If the lads are found to be defective they should be replaced. Non When replacinl leads it is imponant to use the same type and lengtb of wire as tbe resistance of the leads is critical (or proper operation of tbe pup. 1C-348. Cl ..... , and 1aIpectioa.

Unless mechanical damate is evident. broleen pass. bent or broken pointer or broken case. the foUowin, cbecks should be pcrfonned befoЈe remo v ing the instrument. a. Remove probe from exhaust stack and check for broken weld (at tip end) or burnt end. Measured resistance of probe should be .8 ohms. b. Disconnect lead wira at instrument and measure resistance of lead wires. Resistance witb lead wires connected to probe sbould be J.J ohms. CAUTION Do not connect obmmeter across meter. It will bum-out the movement of the meter. c. With leads connected to instrument. heat probe with propane torch to dull red. The meter should read up to the fourth graduation. or approximately I SOOO F.

If the meter does not mo v e. replace it. T AILE VlIC-JA TROlJ"BLESHOOTING CHART (MIXTURE CONTROL INDICATOR) POWERPLANT ADDED: 9/10/79 2H2 TROUBLE CAUSE REMEDY Gause inoperative Defective pUIC. probe or wirina. Checle probe and lead wires for chafin,. breaks or shortinl between wires and or metal structures. Fluctuating readinl Loose. frayed or broken electrical leads or faulty connections. Clean and tighten con- nections. Repair or replace defective leads.