BAIC — BAIC Comanche Service Manual: Comprehensive Guide for PA-24 Series Aircraft

PIPER COMANCHE SERVICE MANUAL a. In:r-..3ll mIXtUre concrol cable bracket on injector unit and secure with screws and safety wire. b. Install injector unit with psket on enpne and hold in place witl:a washers and nua on the two front mounnn, studs. 1C41. InnaUadoa Of Fuel Injector. c. 1nsW1 the inboard turbocharpr support braces scc:urinc them to ach aft injector mountint srud. to each turbocharpr inboard mounUntIUl and to the eftlinc sump. d. Safety the fuel injectOr lIlOuntiDI nulS with pal DUIS and safety wire the cap screws seCUM!I the turbochuJer support braces to the eqiDc sump. e. Connect the inlet and oudet fuelliDes to the iDjeCtorunit. f.

Connect the throttle and mixtureconrrol cables to the injee:tOr unit and adjult per parqn.ph 1C-42. ,. IllIW1acion compteslOr dischatp box with pet OD injectOr unit and sceure with cap screws and s&fetywire. . h. Connect flexible dum from compressor outlet to compreuor discharge box and secure with damps. Install en,ine cowlinl. (Refer to parqraph 7C·1.) J. i, Adjust idle speed and mixture. (Refer to pancnPh 1C....3.) 1C-42. Adjustment Of Thrordc And Mlxrun Con~ls.

Thc throttle and mixture controls are adjusted when the throttle um on the injector is rotated forwll'Cl apinst its full throttle stop and the mixture ann is rotated forward .ainst ia full rich stOp, their respective cockpit control should be .062 of an inch in from their full forward SlOpS. a. At the injector. disconnect the throttle and/or mixture control cable end from its control ann. b. Loosen the jam nut SCC\lnn, the cable end. c. Adjust the Iink.,c by rotating the cable md to obtain the .062 of an inch spring back of the cockpit control lever when the throttle or mixture control ann contactS its StOp. d. Reconnect the cable end to its control ann and secure jam nut. c.

Pull the throtde and mixture controls in t.he cockpit full aft to ascertain that the injector idle screw contacts its SlOp ud the mixture cona-olann contaCts its lun position. 1C 4 3. Adjultlllatt Of Idle Speed AlId Mixture. 1. Start the enginc and warm 'up in the usual manner until oil and cylinder head temperatures are normal. b. Check mapcros. If the "lftII"drop" is normal. proceed with idle Ґijuscment. c. Close the throttle to idle. If the RPM changes appreciably after maJt.ing the idle mixture adjustment during the succcedinl steps. readjust the idle speed to the desired RPM. NOTE The idle mixture must be adjUSted with the fuel boose pump "ON". POWER PLANT ISSUED: 8/18/72 2 H8