PIPER COMANCHE SERVICE MANUAL a. OiscollDCC't the c1unpt tbar secure die wiIa to the mpae IDd &CcaIOries. b. Loosen the cOllpliJll nlla at the spark pillp and remove eIle iDsulaton from the spark plu, bane! wcU. Use caution wben widldrawinl ttle iDsu!acor not to cIaInIp the iDsu1alor SPriDl. 7C·57. Remcm1 Of HtmIa. c. Place a pard over the IwDas iDlWaror. d, .Remove the b&mcu UlClllbly tamiD&l place hom tb~ mapetO. e. Remove tile mpae bUile place thac receives the bamea .-albly. f. Remove the hamal from the airplaae. 7C·58. I .... n·rio'll Of~. Before josqm,. hameu on mapcto. check raarm, surfaces for cleanliness. Spray mare face of P'Oa:t.IIIft wim a upt cou of Pwac Mold Spray.
SM"()"()-TH Silicone Spray or eqlliwent. Thil will Prcmlt b.amaI pooDIIDec from Rickiac to m.apeto diftribucorblock. a. Place die barDesI termiDal plate on the mapeto ~ tiPmn allts around ttle place alcernately to sac cover squ.areJyon rn&petO. Torque screws co 18 to %% inch pounds. b. Route ipition wins to their respective cyliftdcn. c. Clamp the ham .. UMIIIbly in position and replace the enpe baffle plate. d. COIUleC't r.beleads to die spuk plup. 7C·59. Spark Plup. 7C-60. Remcml Of Spck Plup. a. Loo$CD the couplinJ nut on the bamea lad and remove the mmiDat iDsulator from the spark plue bam:! well.
NOTE When widu:in.wq the iplition cable lead cormcction from the plug, c:a.re must be taken to pull the lad straipt OUt and in line with the cmter liDe of me plUl butel; othenrile. a side load will be applied w::1ic:b frequently resWQ in cIuDIp to the banel insulacor aDd coMel:tor. If tbe lead cannot be removed easily in mis manner. the resil'ti.q c:onaec between tbe neoprene collar UICI the banel insulator will be broken by a rotarY twistin, of the coUar. Avoid undue distortion of the coUat and po.ble side loadiftl of the banel insulator. b. Remove the spark plUl from the eapae. In me course of e.e operation.
carbon and other combustion produca will be deposited on the end of the spark plul and will penetrate the lower threads to some degree. As a tawt. pater torque is frequently required for mnovUlg a plug than for its insu.llacion. Accordiftlly. the torque limitations given do not apply to plUl removal and sufficient torque must be used to unscrew the plu•. The hilber torque in removal is not as dcaimena.l as in insoa11arion, since it cannot stretch the threaded section. It does. however. impose a sbearin, load on thlS section and may. if sufficiently severe. produce a failure in this location. POWER PLANT ISSUED: 8/18/72 2 H18