PIPeR COMANCHE SeRV\CE MANUAL a. When conduetin. a routine encine inspection, the oil eeeler, lines and fittings should be checked for the foUowinJ: 1C-68. Oil Cooler. 1. Oil cooler line attachments should be examined to be Ceru1D thu all are ~ilht and there is no indication oi crOSltbreadinJ. (Sec C for oil line torque.) 2. Oil lines mua have adequate clearance and be properly aliped. 3. Oil line supportS should be titbt. property positioned and if wom should be replaced, ~. Oil cooler should be checked for I~ or discon:ed cells. , . Coolin. fiDs should be clean &ad unclamqcd. b. Dunn, each cupne overhaul; atindicuions of bith oiltntpentures or dunn, a 500 hour inspection.
the oil cooler should be removed; daned aDd checked for dam.d fltlS and cells. When replac:m, the cooler. properly a1ipl aDd do not over tilinen the mOWltifti bolts so that the cooler would be e:tamaccd. While the oil cooler is removed. the oil lina should be dUcoMected and flushed. c. If it is found that oil is leaking around the line compression nua. cbeck that the nuts arc tilhtened to 125 inch pound Wet torque or the nut may be backed off. rctiPtened ftlll" tiCht, plus a 314 tum. Do nOt over torque. d. Should oil continue to leak. it may be necessary to replace the seal rings.
Also remove the c;ompression nuts and inspect the line ends in the area of the swaged ferrules for collapsed rubin,. This condition may be observed by lookq intO the cubint ends. Should the the cubing show indications that It is collapsed and new scaI rinp and proper torque does not StOp lcakap. the oillincs should be replaced. Also inspect the surfaces of the mann, fininp for dam 7C-69. Recommendations For Chanlina Oil. (Ref. latest Lye. S.l. No. 1014.) a. If an additive oil is wed in a new eDJinc. OT a newly ovcmauled engine. high oil consumption miJht possibly be experienced. The antiofrietion additives of some oi these oils will retard the break-in oi the piston rinp 1I\d cylinder walls.
This condition is easily eerreeted by the usc of straight mineral 011 until normal oil consumption is obtained, then ehanF to the additive type. b. In erlJincs that have been opcratirlJ on sttailht mineral oil for more than 100 houn. a ch to detergent oil should be made with a degree of caution, the deaning ac:tion of a detCfJent oil will tend to loosen sludge deposia and caUsc pluacd oil pusqcs. In fact. if an engine has been operanng on stra~i\t mineral oil. and known to be in cxcessividy dirty condition. the switch to detergent 011 should be deren-cd until after the enpne is overhauled. c.
When chanlin, from straight mincraJ oU to detergent oil, the following precautionary steps should be taken: 1. Do not add detergent oil ee Straight mineral oil. Drain the straight minen.1 oil from the eftilne ancl rill with detergent oil. 2. Do not operate the cngine lonpt than five hours before the fim oil change .. 3. Check oil screen filter for evidence of sludge or pluaing. Change oil every tcn hours if sludge conditions arc evidenr, Resume normal oil drain periods after slild,c ccndinons improve. POWER PLANT REVISED: 4/10/81 2 H23